RT8820A
Parameter
VOUT Soft-Start
Symbol
Test Conditions
Min
Typ
Max
Unit
From VEN = high to VOUT regulation
point, VREFIN = 1V
--
0.5
--
ms
(PGOOD Blanking Time)
Error Amplifier
VSNS Error Comparator
Threshold (Valley)
V
REFIN = 1V
11
6
1
mV
V
Reference
Sourcing current = 1mA, VID no
switching
Reference Voltage
VVREF
1.98
2
2.02
Driver On-Resistance
UGATE Driver Source
UGATE Driver Sink
LGATE Driver Source
LGATE Driver Sink
RUGATEsr
BOOTx PHASEx forced to 5V
--
--
--
--
--
--
2
4
2
RUGATEsk BOOTx PHASEx forced to 5V
1
RLGATEsr
RLGATEsk
LGATEx, high state
1.5
0.7
30
20
3
LGATEx, low state
1.5
--
From LGATE falling to UGATE rising
From UGATE falling to LGATE rising
Dead-Time
ns
--
Internal Boost Diode
Resistance
RBOOT
PVCC to BOOTx, IBOOT = 10mA
--
80
--
Note 1. Stresses beyond those listed under “Absolute Maximum Ratings” may cause permanent damage to the device.
These are stress ratings only, and functional operation of the device at these or any other conditions beyond those
indicated in the operational sections of the specifications is not implied. Exposure to absolute maximum rating
conditions may affect device reliability.
Note 2. θJA is measured under natural convection (still air) at TA = 25°C with the component mounted on a high effective-
thermal-conductivity four-layer test board on a JEDEC 51-7 thermal measurement standard. θJC is measured at the
exposed pad of the package.
Note 3. Devices are ESD sensitive. Handling precaution is recommended.
Note 4. The device is not guaranteed to function outside its operating conditions.
Note 5. Not production tested. Test condition is VIN = 8V, VOUT = 1V, IOUT = 20A using application circuit.
Copyright 2020 Richtek Technology Corporation. All rights reserved.
©
is a registered trademark of Richtek Technology Corporation.
DS8820A-01 February 2020
www.richtek.com
7