RT8152A/B
Pin No.
Pin Name
Pin Function
Current Monitor Output. This pin outputs a voltage proportional to the
output current.
10
11
12
CM
Current Monitor Output Gain Externally Setting. Connect this pin with one
resistor to VSEN while CM pin is connected to ground with one another
resistor. In such way, current monitor output gain can be set by the ratio of
these two resistors.
CMSET
VSEN
Positive Voltage Sensing Pin. This pin is the positive node of the
differential voltage sensing.
13
14
15
16
17
FB
Feedback. This is the negative input node of the error amplifier.
Compensation. This pin is the output node of the error amplifier.
Negative input of the current sense.
COMP
ISEN_N
ISEN
TON
Positive input of the current sense.
Connect this pin to VIN with one resistor.
18,
Ground. The exposed pad must be soldered to a large PCB and
connected to GND for maximum power dissipation.
GND
33 (Exposed Pad)
19
20
21
PVDD
LGATE
PGND
Driver Power.
Lower Gate Drive. This pin drives the gate of the low side MOSFETs.
Driver Ground.
This pin is return node of the high-side MOSFET driver. Connect this pin to
the high side MOSFET sources together with the low side MOSFET drains
and the inductor.
22
PHASE
23
24
UGATE
BOOT
Upper Gate Drive. This pin drives the gate of the high side MOSFETs.
Bootstrap Power Pin. This pin powers the high side MOSFET drivers.
Connect this pin to bootstrap capacitor.
Voltage ID. DAC voltage identification inputs for IMVP6.5.
The logic threshold is 30% of the VCCP as the maximum value for low
state and 70% of the VCCP as the minimum value for the high state.
VID6 to
VID0
25 to 31
32
Voltage Regulator Thermal Throttling. This open-drain output pin will be
pulled low when the preset temperature level is exceeded.
VRTT
www.richtek.com
4
DS8152A/B-04 April 2011