RA D I O F R E Q U E N C Y I D E N T I F I C A T I O N SY S T E M S
Data Sheet
Mount-on-Metal Transponder
Specifications:
Part Number
RI-TRP-R9VS
RI-TRP-W9VS
Functionality
Read Only
Read/Write
Memory (Bits)
64
80*
1
Memory (Pages)
Operating Frequency
Modulation
1
134.2 kHz
FSK (Frequency Shift Keying) 134.2 kHz / 123.2 kHz
HDX (Half Duplex)
Transmission Principle
Power Source
Powered from the reader signal (batteryless)
≤ 120 cm**
Typical Reading Range
Typical Programming Range
Typical Reading Time
Typical Programming Time
Typical Programming Cycles
Operating Temperature
Storage Temperature
Case Material
---
30 % of typical reading range
70 ms
---
309 ms
100,000
---
-25 to +70°C***
-25 to +85°C
Polypropylene, black
IP 67 ( product revision –11 )
Protection Class
Mounting
With screws or rivets on aluminum, iron or steel
EMC
Programmed code is not affected by normal electromagnetic interference or x-rays
Transponder can be read through virtually all non-metallic material
IEC 68-2-27, Test Ea; 200 g, half sine, 3 ms, 3 axes, 6 shocks per axis
IEC 68-2-6, Test Fc; 20 g, 20 - 500 Hz, 3 axes, 10 cycles per axis
102 mm ± 1 mm * 36 mm ± 1 mm * 16.5 mm ± 1 mm
43 g
Signal Penetration
Mechanical Shock
Vibration
Dimensions
Weight
*
We recommend that you split each 80 bit page into 64 user programmable bits plus a 16 bit wide CRC CCITT Block Check Character as is done
by TI-RFID LF readers.
** Depending on RF regulation in country of use, the Reader Antenna configuration used, and the environmental conditions.
*** Reduced operating temperature of 0 to +70°C if used with Series 2000 Standard Reader (RI-STU-MB2A/MB6A) or Standard RFM (RI-RFM-104B)
For more information, contact the sales office or distributor nearest you. This contact information can be found
on our web site at:
http://www.ti-rfid.com
Texas Instruments reserves the right to change its products and services at any time without notice. TI provides customer assistance in various
technical areas, but does not have full access to data concerning the uses and applications of customers products. Therefore, TI assumes no
responsibility for customer product design or for infringement of patents and/or the rights of third parties, which may result from assistance
provided by TI.
© Copyright 2001 Texas Instruments Incorporated.
Data Sheet: 11-09-22-065 07/01