RA8911
Version 1.5
8-Bit Micro-Controller
Bit-6 of Port 3
PT3_6
PT3_5
PT3_4
I/O
I/O
I/O
This is a programmable pin for general-purpose I/O Port 3. The driving current
and pull-high or pull-low can be selected by user register.
Bit-5 of Port 3
This is a programmable pin for general-purpose I/O Port 3. The driving current
and pull-high or pull-low can be selected by user register.
Bit-4 of Port 3
This is a programmable pin for general-purpose I/O Port 3. The driving current
and pull-high or pull-low can be selected by user register.
Bit-3 of Port 3
PT3_3
TX
I/O
I/O
I/O
I/O
The PT3_3 is also as the transmission output of user’s UART. In UART mode,
the pin is always output except the power saving mode.
Bit-2 of Port 3
PT3_2
RX
The PT3_2 is also as the receive input of user’s UART. In UART mode, the pin
is always input.
Bit-1 of Port 3
PT3_1
LCD_E
PT3_0
LCD_RW
The PT3_1 is also as the chip enable of external LCD controller. If the external
LCD enabled, the pin is always output except the power saving mode.
Bit-0 of Port 3
The PT3_0 is also as the read/write signal of external LCD controller. If the
external LCD enabled, the pin is always output except the power saving mode.
Bit 7~0 of Port 4
PT4_[7:0]
IOUT
I/O
This is a programmable pin for general-purpose I/O Port 4. The driving current
and pull-high or pull-low can be selected by user register.
DAC Current Output
OUT
This pin is the current output of DAC.
ADC Analog Input
These pins are the analog input of 10-bit ADC for 4-channel.
ADC Mode
Touch Panel Mode
AIN[3~0]
IN
--------------------------------------------------
AIN0
AIN1
AIN2
AIN3
X1
X2
Y1
Y2
14-bit Address Bus.
These signal are used for external memory address bus.
8-bit Data Bus.
These signal are used for external memory data bus.
Flash Chip Select, active low.
ADDR[13:0]
D[7:0]
OUT
I/O
FL_CE#
OUT
This signal is used for external flash.
Flash Write Enable, active low.
This signal is used for external flash.
If REG[1032h] bit6 is set as 1, and then FL_WE# and MEM_WE can be jointly
used.
FL_WE#
FL_OE#
OUT
OUT
Flash Output Enable, active low.
This signal is used for external flash.
If REG[1032h] bit6 is set as 1, and then FL_OE# and MEM_OE# can be jointly
used.
7/10
RAiO TECHNOLOGY INC.
www.raio.com.tw