PMA-xxxxTLF
Mainzer Straße 151–153
D-55299 Nackenheim
Tel. +49 6135 7026-0
Fax: +49 6135 931070
www.peak-electronics.de
peak@peak-electronics.de
PSD-SERIES
ꢀ 1 Watt
ꢀ Unregulated
Rev.04-2009
ꢀ Dual Output – Full Pin
ꢀ SMD Case
ꢀ 1 kV DC I/O Isolation
ꢀ Low Ripple and Noise
The PMA-xxxxZLF series is a family of cost effective 1 W dual output
DC/DC converters. These converters are in an ultra miniature SMD 10-pin
case. Devices are encapsulated. High performance features: 1000VDC
input/output isolation, industrial standard pinout, high power density, no
heatsink required
All specifications typical at Ta=25°C, nominal input voltage and full load unless otherwise specified
Input Specifications
Voltage Range
10%
Output Specifications
Voltage Accuracy
Short Circuit Protection
Line Regulation
5%, typ.
Short Term
1.2%, max. (For Vin Change of 1%)
Load Regulation (10% - 100%)
5 Vout 15%, max.
9, 12, 15, 24 Vout
10%, max.
75 mV pk-pk, max.
0.03% / °C
Ripple and Noise (20Mhz bandwidth)
Temperature Coefficient
General Specifications
Efficiency
I/O Isolation Voltage (3 sec.)
I/O Isolation Resistance (Tested at 500 VDC)
Switching Frequency
Humidity
See Table
1000 VDC
1000 M Ohm
100 kHz, typ (5, 12 Vin); 500 kHz (24Vin)
95% rel H
Reliability Calculated MTBF (MIL-HDBK-217F) > 3500 khrs
Physical Specifications
Case Material
Potting Material
Weight
Non Conductive Black Plastic (UL94V-0 rated)
Epoxy (UL94V-0 rated)
~ 1.7g, typ.
Environment Specifications
Operating Temperature
Storage Temperature
Cooling
Soldering
RoHS Conform
-40 to +85°C (ambient)
-55 to +125°C
Free Air Convection (10mm distance required)
Not usable for heat steam soldering
PSD-Series – PMA-xxxxTLF – Dual Output – SMD - Plastic Case
Specification can change without a notice – We accept no liability for any inaccuracy or printing errors.
Page 1/4