SMD POWER INDUCTOR
(续上表 Continue the above table)
序号
项目
要求
试验方法及备注
No.
Items
Requirements
Test Methods and Remarks
使用焊料将电感器焊接到试验板上,试验板固定于振动试
验夹具使之与振动台刚性连接。试验按以下条件进行:
振动频率范围:10Hz~55Hz
振幅:1.5mm(加速度≤196m/s2)
一次循环时间:1min(10Hz→55Hz→10Hz)
振动时间:X/Y/Z 轴各 2H(共 6H)
外观无可见机械损伤;
振动
电感量变化率:±10%以内。
The inductor is welded to the test plate with solder,and
10
Vibration
No visible mechanical damage. the test plate is fixed to the vibration test fixture so that it
Inductance change: Within ±10% is rigidly connected with the vibration table. The test shall
be conducted according to the following conditions:
Vibration frequency range: 10Hz~55Hz
Amplitude: 1.5mm (Acceleration ≤ 196m/s2)
One cycle time: 1min (10Hz → 55Hz → 10Hz)
Vibration time: 2 hours for X/Y/Z axis ( Total of 6 hours)
使用焊料将电感器焊接到试验板上,然后施加一个垂直方
向的力(如图所示),试验按以下条件进行:
弯曲度:2mm
加压速度:0.5mm/s
保持时间:30±1s
测试板厚度:1.0mm
The inductor is welded to the test plate with solder, and
then apply a vertical force (as shown in the figure). The
test shall be conducted according to the following
conditions:
弯曲试验
外观无可见机械损伤;
11
Curvature: 2mm
Resistance to Flexure
No visible mechanical damage.
Pressurization speed: 0.5mm/s
Holding time: 30 ± 1s
Thickness of test plate: 1.0mm
温度 85 ℃±2℃,时间 1000+02 4h,施加额定电流,在室温下
放置 2 小时后、48 小时内测试。
Temperature 85 ℃± 2 ℃, Time 1000+02 4h,apply a rated
current, test within 48 hours after 2 hours of placement at
高温负载
(寿命)
外观无可见机械损伤;
room temperature.
电感量变化率:±10%以内。
12
High-temperature Load
(Life-span)
No visible mechanical damage.
注:加载电流时零件表面温度超过 125℃的,需要对电流
Inductance change: Within ±10%
降额到零件表面温度不超过 125℃。
Note: If the surface temperature of the part over 125 ℃
when the current is loaded, the current need to reduce
until the surface temperature of the part less than 125 ℃.
6