Datasheet > NCA9306GX

NCA9306GX

更新时间： 2023-09-03 20:28:31

品牌	Logo	应用领域
安世 - NEXPERIA		/
页数	文件大小	规格书
14页	229K
描述
2-bit bidirectional multi-voltage level translator; open-drain; push-pullProduction

阅读下载

中文翻译

获取价格

数据手册

如果您发现信息不准确，欢迎纠错

NCA9306GX 数据手册

NCA9306

2-bit bidirectional multi-voltage level translator; open-drain;

push-pull

Rev. 2 — 26 November 2021

Product data sheet

1. General description

The NCA9306 is a 2 channel bidirectional I²C and SMBus multi-voltage level translator with an

enable (EN) pin input. It allows voltage translation between 0.95 V and 5 V without the use of a

direction pin. It supports up to 100 MHz up translation and >100 MHz down translation at ≤ 30 pF

capacitive load. There is no need for a direction pin which minimizes the system effort. The

NCA9306 supports 5 V tolerant I/O pins to support mixed mode signal operation. The ability to set

up different voltage translation levels on each channel makes the device very flexible and suitable

for a lot of different applications.

The low ON-state resistance R_ONof the switch allows connections to be made with minimal

propagation delay. When EN is HIGH, the translator switch is on, and the SCLA and SDAA I/O are

connected to the SCLB and SDAB I/O respectively, allowing bidirectional data flow between ports.

When EN is LOW, the translator switch is off, and a high-impedance state exists between ports. As

with the standard I²C bus-system, pull-up resistors are required to provide the logic HIGH levels on

the translators bus. The NCA9306 has a standard open-drain configuration of the I²C-bus. The size

of these pull-up resistors depend on the system. Each side of the translator must have a pull-up

resistors. NCA9306 is designed to work with Standard-mode, Fast-mode and Fast-mode plus

I²C bus devices in addition to the SMBus devices.

When the SDAA or SDAB pin is LOW, the clamp is in the ON-state and a low resistance

connections exists between the SDAA and SDAB ports. Assuming the higher voltage is on the

SDAB port when the SDAB port is HIGH, the voltage on the SDAA port is limited to the voltage set

by refA. When the SDAA port is HIGH, the SDAB port is pulled to the refB supply voltage by the

pull-up resistors. The SCLA or SCLB pins also follows the same behavior as described for SDAA or

SDAB pins.

2. Features and benefits

•

2-channel bidirectional voltage translator for SDA and SCL lines in mixed mode I²C bus

applications

•

Open-drain I²C-bus I/O ports (SCLA, SDAA, SCLB and SDAB)

Provides bidirectional voltage translation with no direction pin

High-impedance SCLA, SDAA, SCLB and SDAB for EN = LOW

Up translation

•

< 100 MHz; C_L= 30 pF

< 40 MHz; C_L= 50 pF

•

Down translation

•

> 100 MHz; C_L= 30 pF

< 40 MHz; C_L= 50 pF

•

Hot insertion

Bidirectional voltage level translation between:

•

0.95 V and 1.8 V, 2.5 V, 3.3 V and 5.0 V

1.2 V and 1.8 V, 2.5 V, 3.3 V and 5.0 V

1.8 V and 2.5 V, 3.3 V and 5.0 V

2.5 V and 3.3 V and 5.0 V

3.3 V and 5.0 V

•

Low standby current

5 V tolerant I²C-bus I/O pins to support mixed mode signal operation

12 3 4 5 6 7...14

中文翻译

下载PDF

与NCA9306GX相关器件

型号	品牌	获取价格	描述	数据表
NCA9511	NOVOSENSE	获取价格	NCA9511是可热插拔的I2C总线缓冲器，支持将I/O卡插入带电背板，而不会损坏数据和时
NCA9534B	NOVOSENSE	获取价格	NCA9534B是一款16引脚CMOS器件，提供8位通用并行I2C总线数输入/输出GPIO
NCA9535BY	NEXPERIA	获取价格	Low-voltage 16-bit I2C and SMBus low-power I/O expander with interrupt output and configur
NCA9535BY-Q100	NEXPERIA	获取价格	Low-voltage 16-bit I2C and SMBus low-power I/O expander with interrupt output and configur
NCA9535PW	NEXPERIA	获取价格	Low-voltage 16-bit I²C and SMBus low-power I/
NCA9535PW-Q100	NEXPERIA	获取价格	Low-voltage 16-bit I²C and SMBus low-power I/
NCA9539BY	NEXPERIA	获取价格	Low-voltage 16-bit I2C and SMBus low-power I/O expander with interrupt output, reset pin a
NCA9539BY-Q100	NEXPERIA	获取价格	Low-voltage 16-bit I2C and SMBus low-power I/O expander with interrupt output, reset pin a
NCA9539PW	NEXPERIA	获取价格	Low-voltage 16-bit I²C and SMBus low-power I/
NCA9539PW-Q100	NEXPERIA	获取价格	Low-voltage 16-bit I²C and SMBus low-power I/

与NCA9306GX相关文章

压敏电阻器在直流电路中的过压保护应用探讨
2024-06-07

10
电感耐压值及其与电感大小的关系
2024-06-07

14
CNY17F光耦合器：特性、应用、封装、引脚功能及替换型号解析
2024-06-07

17
DS1307资料解析：特性、引脚说明、替代推荐
2024-06-07

10

产品中心

服务支持

精选活动

关于我们

帮助中心

NCA9306GX

NCA9306GX 数据手册

与NCA9306GX相关器件

与NCA9306GX相关文章

您还可以找

产品中心

服务支持

精选活动

关于我们

帮助中心

NCA9306GX

NCA9306GX 数据手册

与NCA9306GX相关器件

与NCA9306GX相关文章

您还可以找

您在本页遇到什么问题？