FEDL22620-05
ML22620
Initial
Pin
28
Symbol
I/O
I
Attribute
Negative
Description
value *1
Reset input pin.
The LSI is initialized by the "L" level input. After a reset is input, all the
circuits stop operating and enter the power-down state.
At power-on, input an "L" level to this pin. After the power supply
voltage stabilizes, set this pin to an "H" level.
RESETB
(*2)
A pull-up resistor is internally connected.
Input pin for testing.
29
30
TEST0
I
Positive A pull-down resistor is internally connected.
Fix to the DGND.
L
Status/error output pin 1.
Execute OUTSTAT command to select BUSYB*3 and NCR*3 in each
STATUS1
O
-
H
channel, or errors.
The initial value is BUSYB*3 of channel 0, and output data is "H" level.
Status/error output pin 2.
Execute OUTSTAT command to select BUSYB*3 and NCR*3 in each
31
32
STATUS2
O
-
H
channel, or errors.
The initial value is BUSYB*3 of channel 0, and output data is "H" level.
Command processing status signal output pin.
CBUSYB
N.C.
O
-
Negative An "L" level is output during command processing.
Be sure to input a command with this pin at an "H" level.
(*2)
2,8,
15,25
Unused pin.
Leave open.
-
Hi-Z
*1 Initial value at reset input and power-down. The pin whose IO is "I" indicates a fixed level from outside.
*2 "L" at reset, "H" at power-down
*3 For NCR, BUSYB, refer to the description of "RDSTAT command".
■ Termination of Unused Pins
This section explains how to terminate unused pins.
Symbol
EROFF
XT
Recommended pin termination
Connect to the DGND.
Leave open.
XTB
AIN
TEST0
N.C.
Connect to the SPGND.
Connect to the DGND.
SO
SPM
Leave open.
STATUS1
STATUS2
7/121