Datasheet > MC34118G-E28-T

MC34118G-E28-T

更新时间： 2024-02-06 10:55:45

品牌	Logo	应用领域
友顺 - UTC		电话
页数	文件大小	规格书
12页	297K
描述
VOICE SWITCHED SPEAKER-PHONE CIRCUIT

阅读下载

获取价格

技术参数
数据手册

如果您发现信息不准确，欢迎纠错

MC34118G-E28-T 技术参数

是否Rohs认证：	符合	生命周期：	Active
零件包装代码：	DIP	包装说明：	HALOGEN FREE, SDIP-28
针数：	28	Reach Compliance Code：	compliant
HTS代码：	8542.39.00.01	风险等级：	5.58
JESD-30 代码：	R-XDIP-T28	长度：	25.6 mm
功能数量：	1	端子数量：	28
最高工作温度：	60 °C	最低工作温度：	-20 °C
封装主体材料：	UNSPECIFIED	封装代码：	SDIP
封装等效代码：	SDIP28,.4	封装形状：	RECTANGULAR
封装形式：	IN-LINE, SHRINK PITCH	峰值回流温度（摄氏度）：	NOT SPECIFIED
电源：	3.5/6.5 V	认证状态：	Not Qualified
座面最大高度：	4.31 mm	子类别：	Telephone Circuits
最大压摆率：	0.008 mA	标称供电电压：	5 V
表面贴装：	NO	技术：	BIPOLAR
电信集成电路类型：	SPEAKER PHONE CIRCUIT	温度等级：	OTHER
端子形式：	THROUGH-HOLE	端子节距：	1.778 mm
端子位置：	DUAL	处于峰值回流温度下的最长时间：	NOT SPECIFIED
宽度：	10.16 mm	Base Number Matches：	1

MC34118G-E28-T 数据手册

MC34118

LINEAR INTEGRATED CIRCUIT

FUNCTIONAL DESCRIPTION

INTRODUCTION

Between operation of a speakerphone and a handset, the fundamental difference is that of half-duplex versus

full-duplex. The UTC MC34118 includes the necessary level detectors, attenuators, and switching control for a

properly operating speakerphone. The detection sensitivity and timing can be externally controlled. The UTC

MC34118 also provides background noise monitors to make the circuit insensitive to room and line noise, hybrid

amplifier to interface to Tip and Ring, the microphone amplifier, and other associated functions.

ATTENUATORS

The transmit and receive attenuators are complementary in function, and they are never both fully on or both

fully off. For example, when one is at maximum gain: +6dB, the other is at maximum attenuation: -46dB, and vice

versa. But sum of their gains remains constant at -40dB typically. To control the transmit and receive paths to

provide the half-duplex operation required in speakerphone is the attenuators’ purpose. The attenuators are

non-inverting, have a -3dB (from max gain) frequency of ~100kHz, their input impedance of each one is nominally

10kꢀ, and to prevent distortion, their input signal should be limited to 350 mVrms(same as 990mvp-p). After the

output current limit (typically 2.5mA) is reached, the output impedance is<10ꢀ.

10kꢀ

TXI/RXI

To Attenuator Input

4.0kꢀ

96Kꢀ

These attenuators can be controlled by the Control Block’s output signal. When the CT pin which measures the

signal is at +240mV with respect to VB, the circuit is in the receive mode and so receive attenuator is at +6dB. When

the CT voltage is equal to VB, the circuit is in an idle mode, and it also causing the attenuators’ gains to be halfway

between their fully on and fully off positions (typical -20 dB each). The most direct method to monitor the circuit’s

mode is monitoring the CT voltage (with respect to VB).

LEVEL DETECTORS

There are two level detectors on the receive side and two level detectors on the transmit side. The terms in

parentheses form one system, and the other terms form the second system. All the four level detectors are high

amplifiers which have back-to-back diodes in the feedback path, and then it is resulting in non-linear gain, which

permits operation over a wide dynamic range of speech levels. TLI1, TLI2, RLI1, and RLI2, the external resistor and

capacitor determine the sensitivity of each level detector. Through a diode each output charges an external capacitor

and limiting resistor, thus providing a DC representation of the input AC signal level. The capacitor and an internal

350ꢀ resistor provide the outputs’ quick rise time. And an internal current source and the capacitor set a slow decay

time. On the receive side, RLI1 is at the receive input receiving the same signal as at Tip and Ring, and RLI2 is at

the output of the speaker amplifier. On the transmit side, TLI2 is at the microphone amplifier, while TLI1 is at the

hybrid output.

UNISONIC TECHNOLOGIES CO., LTD

7 of 12

www.unisonic.com.tw

QW-R108-007,D

1...4 5 678 9 10...12

下载PDF

与MC34118G-E28-T相关器件

型号	品牌	描述	获取价格	数据表
MC34118G-S28-R	UTC	VOICE SWITCHED SPEAKER-PHONE CIRCUIT	获取价格
MC34118G-S28-T	UTC	VOICE SWITCHED SPEAKER-PHONE CIRCUIT	获取价格
MC34118L(28DIP)	UTC	Speaker Phone Circuit, Bipolar, PDIP28,	获取价格
MC34118L(28SDIP)	UTC	Speaker Phone Circuit, Bipolar, PDIP28,	获取价格
MC34118L(28SOP)	UTC	Speaker Phone Circuit, Bipolar, PDSO28,	获取价格
MC34118L-D28-T	UTC	VOICE SWITCHED SPEAKER-PHONE CIRCUIT	获取价格

产品中心

服务支持

精选活动

关于我们

帮助中心

MC34118G-E28-T

MC34118G-E28-T 技术参数

MC34118G-E28-T 数据手册

与MC34118G-E28-T相关器件

与MC34118G-E28-T相关文章

您还可以找

产品中心

服务支持

精选活动

关于我们

帮助中心

MC34118G-E28-T

MC34118G-E28-T 技术参数

MC34118G-E28-T 数据手册

与MC34118G-E28-T相关器件

与MC34118G-E28-T相关文章

您还可以找

您在本页遇到什么问题？