5秒后页面跳转
LNK4323D-TL PDF预览

LNK4323D-TL

更新时间: 2022-09-29 19:29:14
品牌 Logo 应用领域
帕沃英蒂格盛 - POWERINT /
页数 文件大小 规格书
22页 1423K
描述
IC OFF-LINE CNTRLR 10W 8SO

LNK4323D-TL 数据手册

 浏览型号LNK4323D-TL的Datasheet PDF文件第4页浏览型号LNK4323D-TL的Datasheet PDF文件第5页浏览型号LNK4323D-TL的Datasheet PDF文件第6页浏览型号LNK4323D-TL的Datasheet PDF文件第8页浏览型号LNK4323D-TL的Datasheet PDF文件第9页浏览型号LNK4323D-TL的Datasheet PDF文件第10页 
LinkSwitch-4  
If the output does not reach VOUT(UVP) during this time then the  
controller will shutdown and restart.  
This allows the BJT emitter voltage to rise until the Schottky diode  
conducts. Emitter current then charges the CVCC until the BJT is  
turned off by the BASE DRIVE pin being pulled low.  
VOUT(UVP) value depends on the set output voltage (VOUT(CV)) and the  
feedback UVP ratio:  
If the supply voltage is above VVCC(ES), then Easy Start has no effect  
on the operation of the controller.  
VOUT UVP = V  
# G  
^
h
^
h
^
h
OUT CV  
FB UVP  
Note VVCC(ES) = 6 V for LNK4114D and LNK4214D, VVCC(ES) = 10 V for  
LNK43x3S, LNK43x3D, LNK4115D and LNK4215D during NSTARTUP cycles,  
after which it reduces to 6 V.  
Easy Start (LNK4114D, LNK4214D, LNK4115D, LNK4215D)  
The Easy Start feature guarantees start-up into large output  
capacitances and allows the output voltage to work down the CC  
chimney close to OV.  
Over-Temperature Protection  
Temperature protection is internal to LinkSwitch-4. The sensor  
measures the junction temperature TJ, which is the hottest part of  
LinkSwitch-4.  
The Easy Start feature uses the BJT emitter current (equal to the  
primary current) to charge the supply capacitor CVCC via an additional  
Schottky diode.  
At temperatures TJ ~ 140 °C, LinkSwitch-4 will shutdown and remain  
in this state until a temperature of TJ ~ 70 °C is reached. Whereby  
LinkSwitch-4 will power-up in the normal sequence.  
This only occurs when the supply voltage has fallen below VVCCES and  
is achieved by altering the sequencing of EMITTER DRIVE pin switching.  
If the supply voltage is below VVCC(ES), and when the base has received  
enough charge, the EMITTER DRIVE pin is released at the same time  
as the BASE DRIVE pin.  
Fꢇꢈ  
Fꢇꢈ  
ꢉꢊ  
ꢉꢊꢋRꢌ  
ꢎꢏꢐꢑꢒ ꢉꢊ  
ꢎꢏꢐꢑꢒ ꢓꢊ  
ꢉꢊ ꢔꢕꢏꢖꢗꢘ  
ꢀꢁꢂꢃꢄ5ꢅꢂ0ꢅ0ꢆ15  
Figure 9. Base Drive Waveforms.  
ꢍꢍ  
Fꢈꢉ  
Fꢈꢉ  
ꢊꢋ  
ꢊꢋꢌRꢍ  
ꢏꢐꢑꢒꢓ ꢊꢋ  
ꢏꢐꢑꢒꢓ ꢔꢋ  
ꢊꢋ ꢕꢖꢐꢗꢘꢙ  
ꢎꢍꢍ Reꢓꢚꢛꢖꢑe ꢍꢗꢖꢖeꢘꢜ  
ꢀꢁꢂꢃꢄꢃꢅꢂ0ꢆ0ꢇ15  
Figure 9b. Base Drive Waveforms – Easy Start mode of Operation.  
7
Rev. F 05/18  
www.power.com  

与LNK4323D-TL相关器件

型号 品牌 描述 获取价格 数据表
LNK454 POWERINT LED Driver IC with TRIAC Dimming, Single-Stage PFC and Constant Current Control for Non-Is

获取价格

LNK454_1011 POWERINT LED Driver IC with TRIAC Dimming, Single-Stage PFC and Constant Current Control for Non-Is

获取价格

LNK454_11 POWERINT LED Driver IC with TRIAC Dimming Single Stage PFC and Constant Current Control for Non Iso

获取价格

LNK454D POWERINT LED Driver IC with TRIAC Dimming, Single-Stage PFC and Constant Current Control for Non-Is

获取价格

LNK454DG POWERINT LED Driver IC with TRIAC Dimming, Single-Stage PFC and Constant Current Control for Non-Is

获取价格

LNK454DG-TL POWERINT LED Driver IC with TRIAC Dimming, Single-Stage PFC and Constant Current Control for Non-Is

获取价格