7.0 Connection Diagram
30027914
8.0 Pad Description
TABLE 1. System Interface Signals
Default Layout
Pad Name
Pad Location
Type
Description
OP3
16
I
OP3: Pin checked during Startup Sequence for configuration option
OP4: I
PG4: I/
O
OP4: Pin checked during Startup Sequence for configuration option
PG4: GPIO
OP4/PG4
26
OP5
32K-
32K+
25
28
27
I/O
O
I
OP5: Pin checked during Startup Sequence for configuration option
NC (if not used) 32.768 kHz Crystal Oscillator
GND (if not used) 32.768 kHz Crystal Oscillator
TABLE 2. UART Interface Signals
Pad Name
Pad Location
Type
Default Layout
Description
RXD
12
13
14
15
I
Host Serial Port Receive Data
Host Serial Port Transmit Data
TXD
O
O
I
RTS# (Note 2)
CTS# (Note 3)
NC (if not used) Host Serial Port Request To Send (active low)
GND (if not used) Host Serial Port Clear To Send (active low)
Note 2: Treat As No Connect If RTS is not used. Pad required for mechanical stability.
Note 3: Connect to GND if CTS is not use.
TABLE 3. Auxiliary Ports Interface Signals
Default Layout
Pad Name
Pad Location
Type
Description
Low active, either Module Reset (active low)
RESET#
2
I
NC or connect to
host
Host main Clock Request. Toggles with Main crystal (X1) enable/
disable
XOSCEN
8
O
PG6
PG7
7
I/O
I/O
GPIO - Default setup LINK STATUS indication
GPIO - Default setup RF traffic LED indication
19
3
www.national.com