5秒后页面跳转
捷配首页

Datasheet > LM358AN/NOPB
LM358AN/NOPB PDF预览

LM358AN/NOPB

更新时间： 2024-01-30 06:47:26
品牌 Logo 应用领域
德州仪器 - TI 放大器光电二极管
页数 文件大小 规格书
33页 1663K
描述
Low-Power, Dual-Operational Amplifiers

阅读下载

获取价格

LM358AN/NOPB 技术参数

是否Rohs认证： 符合生命周期：Transferred
零件包装代码：DIP包装说明：DIP, DIP8,.3
针数：8Reach Compliance Code：compliant
ECCN代码：EAR99HTS代码：8542.33.00.01
风险等级：7.37放大器类型：OPERATIONAL AMPLIFIER
架构：VOLTAGE-FEEDBACK最大平均偏置电流 (IIB)：0.2 µA
25C 时的最大偏置电流 (IIB)：0.1 µA最小共模抑制比：65 dB
标称共模抑制比：85 dB频率补偿：YES
最大输入失调电压：5000 µVJESD-30 代码：R-PDIP-T8
JESD-609代码：e3长度：9.817 mm
低-失调：NO湿度敏感等级：1
负供电电压上限：标称负供电电压 (Vsup)：
功能数量：2端子数量：8
最高工作温度：70 °C最低工作温度：
封装主体材料：PLASTIC/EPOXY封装代码：DIP
封装等效代码：DIP8,.3封装形状：RECTANGULAR
封装形式：IN-LINE包装方法：RAIL
峰值回流温度（摄氏度）：260电源：+-1.5/+-15/3/30 V
认证状态：Not Qualified座面最大高度：5.08 mm
标称压摆率：0.1 V/us子类别：Operational Amplifier
最大压摆率：2 mA供电电压上限：32 V
标称供电电压 (Vsup)：5 V表面贴装：NO
技术：BIPOLAR温度等级：COMMERCIAL
端子面层：Matte Tin (Sn)端子形式：THROUGH-HOLE
端子节距：2.54 mm端子位置：DUAL
处于峰值回流温度下的最长时间：40标称均一增益带宽：1000 kHz
最小电压增益：25000宽度：7.62 mm
Base Number Matches：1

LM358AN/NOPB 数据手册

 浏览型号LM358AN/NOPB的Datasheet PDF文件第1页浏览型号LM358AN/NOPB的Datasheet PDF文件第2页浏览型号LM358AN/NOPB的Datasheet PDF文件第4页浏览型号LM358AN/NOPB的Datasheet PDF文件第5页浏览型号LM358AN/NOPB的Datasheet PDF文件第6页浏览型号LM358AN/NOPB的Datasheet PDF文件第7页 
LM158-N, LM258-N, LM2904-N, LM358-N  
www.ti.com  
SNOSBT3H –JANUARY 2000–REVISED MARCH 2013  
ABSOLUTE MAXIMUM RATINGS(1)(2)  
LM158/LM258/LM358  
LM2904  
LM158A/LM258A/LM3  
58A  
Supply Voltage, V+  
Differential Input Voltage  
Input Voltage  
32V  
32V  
26V  
26V  
−0.3V to +32V  
−0.3V to +26V  
Power Dissipation(3)  
PDIP (P)  
830 mW  
550 mW  
530 mW  
435mW  
830 mW  
530 mW  
TO-99 (LMC)  
SOIC (D)  
DSBGA (YPB)  
Output Short-Circuit to GND (One  
Amplifier)(4)  
Input Current (VIN < −0.3V)(5)  
Operating Temperature Range  
LM358  
V+ ≤ 15V and TA = 25°C  
Continuous  
Continuous  
50 mA  
50 mA  
0°C to +70°C  
−25°C to +85°C  
−55°C to +125°C  
−65°C to +150°C  
−40°C to +85°C  
LM258  
LM158  
Storage Temperature Range  
Lead Temperature, PDIP (P)  
(Soldering, 10 seconds)  
Lead Temperature, TO-99 (LMC)  
(Soldering, 10 seconds)  
Soldering Information  
PDIP Package (P)  
−65°C to +150°C  
260°C  
260°C  
300°C  
300°C  
Soldering (10 seconds)  
SOIC Package (D)  
260°C  
260°C  
Vapor Phase (60 seconds)  
Infrared (15 seconds)  
ESD Tolerance(6)  
215°C  
220°C  
250V  
215°C  
220°C  
250V  
(1) Refer to RETS158AX for LM158A military specifications and to RETS158X for LM158 military specifications.  
(2) If Military/Aerospace specified devices are required, please contact the TI Sales Office/Distributors for availability and specifications.  
(3) For operating at high temperatures, the LM358/LM358A, LM2904 must be derated based on a +125°C maximum junction temperature  
and a thermal resistance of 120°C/W for PDIP, 182°C/W for TO-99, 189°C/W for SOIC package, and 230°C/W for DSBGA, which  
applies for the device soldered in a printed circuit board, operating in a still air ambient. The LM258/LM258A and LM158/LM158A can be  
derated based on a +150°C maximum junction temperature. The dissipation is the total of both amplifiers—use external resistors, where  
possible, to allow the amplifier to saturate or to reduce the power which is dissipated in the integrated circuit.  
(4) Short circuits from the output to V+ can cause excessive heating and eventual destruction. When considering short circuits to ground,  
the maximum output current is approximately 40 mA independent of the magnitude of V+. At values of supply voltage in excess of +15V,  
continuous short-circuits can exceed the power dissipation ratings and cause eventual destruction. Destructive dissipation can result  
from simultaneous shorts on all amplifiers.  
(5) This input current will only exist when the voltage at any of the input leads is driven negative. It is due to the collector-base junction of  
the input PNP transistors becoming forward biased and thereby acting as input diode clamps. In addition to this diode action, there is  
also lateral NPN parasitic transistor action on the IC chip. This transistor action can cause the output voltages of the op amps to go to  
the V+voltage level (or to ground for a large overdrive) for the time duration that an input is driven negative. This is not destructive and  
normal output states will re-establish when the input voltage, which was negative, again returns to a value greater than −0.3V (at 25°C).  
(6) Human body model, 1.5 kΩ in series with 100 pF.  
Copyright © 2000–2013, Texas Instruments Incorporated  
Submit Documentation Feedback  
3
Product Folder Links: LM158-N LM258-N LM2904-N LM358-N  
1234567...33

下载PDF

与LM358AN/NOPB相关器件

型号 品牌 描述 获取价格 数据表
LM358AN-B PHILIPS Operational Amplifier, 2 Func, BIPolar, PDIP8

获取价格
LM358AP TI DUAL OPERATIONAL AMPLIFIERS

获取价格
LM358AP ROCHESTER DUAL OP-AMP, 5000uV OFFSET-MAX, 0.7MHz BAND WIDTH, PDIP8, ROHS COMPLIANT, PLASTIC, DIP-8

获取价格
LM358AP3 TI IC,OP-AMP,DUAL,BIPOLAR,DIP,8PIN,PLASTIC

获取价格
LM358AP8-XX-AR TAITRON Dual Low Offset Operational Amplifier

获取价格
LM358AP8-XX-BL TAITRON Dual Low Offset Operational Amplifier

获取价格

与LM358AN/NOPB相关文章

您还可以找


热门产品
PCB打样/小批量
铝基板
BOM智能配单
PCBA制造
钣金
精密CNC
模具注塑
薄膜开关
精选活动
PCBA打样特惠
四六层板品质升级
铝基板品质升级
一体化电子制造
DFM下载
服务支持
企业认证
产品展示
工厂展示
工艺能力
积分商城
关于捷配
捷配简介
企业文化
公司动态
人才招聘
联系我们
帮助中心
下单流程
付款流程
开票流程
常见问题
全球PCB制造服务专线 400-613-0088

工作时间：9:00-21:00

CEO邮箱：ceo@jiepei.com

投诉邮箱：tousu@jiepei.com

捷配网-微信公众号 微信公众号
捷配网-微信公众号 抖音公众号
资质认证：
合作快递：
支付方式：
Copyright © 2024 Jiepei.com Inc. All Rights Reserved. 版权所有:杭州捷配信息科技有限公司 浙公网安备 33010502006866号 浙ICP备10014259号-119 营业执照ICP证