5秒后页面跳转
LM2925 PDF预览

LM2925

更新时间: 2024-01-03 13:59:05
品牌 Logo 应用领域
美国国家半导体 - NSC 稳压器
页数 文件大小 规格书
8页 226K
描述
Low Dropout Regulator with Delayed Reset

LM2925 技术参数

是否Rohs认证: 不符合生命周期:Obsolete
包装说明:, SIP5,.1,67TBReach Compliance Code:unknown
风险等级:5.92可调性:FIXED
标称回动电压 1:0.8 V最大绝对输入电压:26 V
JESD-609代码:e0最大电网调整率:0.05%
最大负载调整率:0.05%输出次数:1
端子数量:5工作温度TJ-Max:150 °C
工作温度TJ-Min:-40 °C最大输出电流 1:0.5 A
标称输出电压 1:5 V封装主体材料:PLASTIC/EPOXY
封装等效代码:SIP5,.1,67TB认证状态:Not Qualified
子类别:Other Regulators表面贴装:NO
技术:BIPOLAR端子面层:Tin/Lead (Sn/Pb)
端子节距:1.7 mm端子位置:SINGLE
最大电压容差:5%

LM2925 数据手册

 浏览型号LM2925的Datasheet PDF文件第2页浏览型号LM2925的Datasheet PDF文件第3页浏览型号LM2925的Datasheet PDF文件第4页浏览型号LM2925的Datasheet PDF文件第6页浏览型号LM2925的Datasheet PDF文件第7页浏览型号LM2925的Datasheet PDF文件第8页 
Typical Performance Characteristics (Continued)  
Quiescent Current  
Quiescent Current  
Load Transient Response  
DS005268-18  
DS005268-19  
DS005268-17  
Peak Output Current  
Maximum Power  
Output Capacitor ESR  
Dissipation (TO-220)  
DS005268-20  
DS005268-22  
DS005268-21  
Quiescent Current: The part of the positive input current  
that does not contribute to the positive load current. The  
regulator ground lead current.  
Definition of Terms  
Dropout Voltage: The input-output voltage differential at  
which the circuit ceases to regulate against further reduction  
in input voltage. Measured when the output voltage has  
dropped 100 mV from the nominal value obtained at 14V in-  
put, dropout voltage is dependent upon load current and  
junction temperature.  
Ripple Rejection: The ratio of the peak-to-peak input ripple  
voltage to the peak-to-peak output ripple voltage.  
Temperature Stability of VO: The percentage change in ou-  
put voltage for a thermal variation from room temperature to  
either temperature extreme.  
Input Voltage: The DC voltage applied to the input terminals  
with respect to ground.  
Application Hints  
Input-Output Differential: The voltage difference between  
the unregulated input voltage and the regulated output volt-  
age for which the regulator will operate.  
EXTERNAL CAPACITORS  
The LM2925 output capacitor is required for stability. Without  
it, the regulator output will oscillate, sometimes by many  
volts. Though the 10 µF shown is the minimum recom-  
mended value, actual size and type may vary depending  
upon the application load and temperature range. Capacitor  
effective series resistance (ESR) also effects the IC stability.  
Since ESR varies from one brand to the next, some bench  
work may be required to determine the minimum capacitor  
value to use in production. Worst-case is usually determined  
at the minimum junction and ambient temperature and maxi-  
mum load expected.  
Line Regulation: The change in output voltage for a change  
in the input voltage. The measurement is made under condi-  
tions of low dissipation or by using pulse techniques such  
that the average chip temperature is not significantly af-  
fected.  
Load Regulation: The change in output voltage for  
a
change in load current at constant chip temperature.  
Long Term Stability: Output voltage stability under acceler-  
ated life-test conditions after 1000 hours with maximum  
rated voltage and junction temperature.  
Output Noise Voltage: The rms AC voltage at the output,  
with constant load and no input ripple, measured over a  
specified frequency range.  
Output capacitors can be increased in size to any desired  
value above the minimum. One possible purpose of this  
would be to maintain the output voltages during brief condi-  
tions of negative input transients that might be characteristic  
of a particular system.  
5
www.national.com  

与LM2925相关器件

型号 品牌 描述 获取价格 数据表
LM2925T HTC Low Dropout Regulator with Delayed Reset

获取价格

LM2925T NSC Low Dropout Regulator with Delayed Reset

获取价格

LM2925T/A+ ETC Positive Fixed Voltage Regulator

获取价格

LM2925T/B+ ETC Positive Fixed Voltage Regulator

获取价格

LM2926 NSC Low Dropout Regulator with Delayed Reset

获取价格

LM2926T NSC Low Dropout Regulator with Delayed Reset

获取价格