LEG-150W Series– Fixed Output and Dimmable
Switch Mode LED Drivers
Constant Current, Non-Isolated
Black Magic Thermal Advantage™ Metallic Housing
Electrical Specifications
Input Voltage Range:
Input Over-Voltage:
Frequency:
120-277 VAC Nom. (108-305 V Min/Max)
Can endure 320Vac for 48 Hrs, 350Vac for 2 Hrs
50/60 Hz Nom. (47-63 Hz Min/Max)
>0.90 @ full load, 100V through 277V
<_ 20% @ for all loads >80%
<40.0 Amps maximum @ 230 VAC, cold start 25ºC
1.4A@ 120Vac, 0.68A @ 230Vac
150W
Power Factor:
THD:
Inrush Current:
Input Current:
Maximum Power:
Current Accuracy:
Load Regulation:
Leakage Current:
Hold Up Time:
Protection:
± 1% Over input line variation
± 2%
400 uA Typical
Half Cycle
Output Protection: Over-Voltage, Over-Current, and
Short Circuit Protection, reset by power cycling
• Total Power: 75 Watts
• Input Voltage: 100-277 Vac Nom.
• UL Dry & Damp Location Rated
• IP66
Environmental Specifications
Minimum Starting Temp: -30ºC
• High Power Factor
• UL8750, EN61347, CSA 22.2
Maximum Case Temp.
Storage Temperature:
Humidity:
80°C
-40ºC to +85ºC
5% to 95%
Cooling:
Convection
5 to 55 Hz/2g, 30 minutes
Class A
Vibration Frequency:
Sound Rating:
MTBF:
380,000 Hours at full load and 40ºC ambient conditions
per MIL-217F Notice 2
Constant Current - Non Dimming
Output Voltage Output Current Max Output
Max
Efficiency
Model Number
Range (Vdc)
120-425
94-280
(mA ±3%)
Power (W)
EMC:
FCC 47CFR Part 15 Class A compliant
LEG150W-425-C0350
LEG150W-280-C0530
LEG150W-210-C0700
350
148.7
92%
91%
90%
Impact Resistance:
Weight:
1g/s
530
148.4
45 oz (1270 grams)
70- 210
700
147.0
Ordering Options:
Constant Current - 0-10VDC Dimming
-D: 0-10V & Resistance dimmable version comes with an extra two wires +Purple/-Gray
on the output side. 0-10V Dimming is compatible with most quality 0-10V dimmers.
See pg. 3 for more information.
Output Voltage Output Current Max Output
Max
Efficiency
Model Number
Range (Vdc)
120-425
94-280
(mA ±3%)
Power (W)
LEG150W-425-C0350-D
LEG150W-280-C0530-D
LEG150W-210-C0700-D
350
148.7
92%
91%
90%
530
148.4
70-210
700
147.0
E332160
Note:
LED drivers are designed and intended to operate LED loads only.
Non-LED loading may be outside the specified design limits of our
LED drivers, and therefore cannot be covered by any warranty.
If you desire to use our LED drivers to operate non-LED loads
please contact us to discuss compatibility.
Specifications subject to change without notice.
Rev 8-31-15
Thomas Research Products • 1225 Bowes Rd • Elgin, IL 60123 • T 847-515-3057 • F 847-515-3047 • www.trpssl.com