L9951
L9951XP
Rear door actuator driver
Features
(2)
Type
Outputs(1)
Ron
IOUT
VS
OUT1
OUT2
OUT3
OUT4
OUT5
150 mΩ
200 mΩ
200 mΩ
800 mΩ
800 mΩ
7.4 A
5 A
L9951
5 A
28 V
L9951XP
1.25 A
1.25 A
PowerSSO-36
PowerSO-36
1. See block diagram.
2. Typical values.
Applications
■ Rear door actuator driver with bridges for door
lock and safe lock and two 5W or 10W - light
bulbs.
■ One half bridge for 7.4 A load (R = 150 mΩ)
on
■ Two half bridges for 5 A load (R = 200 mΩ)
on
■ Two highside drivers for 1.25 A load
(R = 800 mΩ)
on
Description
■ Programmable softstart function to drive loads
with higher inrush currents (i.e.current > 7.4A,
>5A, >1.25A)
The L9951 and L9951XP are microcontroller
driven, multifunctional rear door actuator drivers
for automotive applications. Up to two DC motors
and two grounded resistive loads can be driven
with three half bridges and two hide side drivers.
The integrated standard serial peripheral interface
(SPI) controls all operation modes (forward,
reverse, brake and high impedance). All
■ Very low current consumption in standby mode
(I < 3µA, typ. T ≤ 85°C)
S
j
■ All outputs short circuit protected
■ Current monitor output for all highside drivers
■ All outputs over temperature protected
■ Open-load diagnostic for all outputs
■ Overload diagnostic for all outputs
diagnostic information is available via the SPI.
■ Programmable PWM control of all outputs
■ Charge pump output for reverse polarity
protection
Table 1.
Device summary
Package
Order codes
Tape and reel
Tube
PowerSO-36
L9951
L9951TR
PowerSSO-36
L9951XP
L9951XPTR
May 2010
Doc ID 14173 Rev 8
1/36
www.st.com
1