5秒后页面跳转
ISD2590 PDF预览

ISD2590

更新时间: 2024-01-12 13:41:37
品牌 Logo 应用领域
华邦 - WINBOND /
页数 文件大小 规格书
42页 377K
描述
ISD2560

ISD2590 技术参数

生命周期:Transferred包装说明:DIE,
Reach Compliance Code:unknownHTS代码:8542.39.00.01
风险等级:5.22Is Samacsys:N
应用:PUSH BUTTON AND MESSAGE CUEING商用集成电路类型:SPEECH SYNTHESIZER WITH RCDG
JESD-30 代码:X-XUUC-N28功能数量:1
端子数量:28片上内存类型:EEPROM
最高工作温度:50 °C最低工作温度:
封装主体材料:UNSPECIFIED封装代码:DIE
封装形状:UNSPECIFIED封装形式:UNCASED CHIP
认证状态:Not Qualified最长读取时间:93 s
最大供电电压 (Vsup):6.5 V最小供电电压 (Vsup):4.5 V
表面贴装:YES技术:CMOS
温度等级:COMMERCIAL端子形式:NO LEAD
端子位置:UPPERBase Number Matches:1

ISD2590 数据手册

 浏览型号ISD2590的Datasheet PDF文件第4页浏览型号ISD2590的Datasheet PDF文件第5页浏览型号ISD2590的Datasheet PDF文件第6页浏览型号ISD2590的Datasheet PDF文件第8页浏览型号ISD2590的Datasheet PDF文件第9页浏览型号ISD2590的Datasheet PDF文件第10页 
ISD2560/75/90/120  
PIN NO.  
PIN NAME  
FUNCTION  
SOIC/ TSOP  
PDIP  
VCCA, VCCD  
16, 28  
17  
23, 7  
24  
Supply Voltage: To minimize noise, the analog and digital circuits  
in the ISD2500 series devices use separate power busses. These  
voltage busses are brought out to separate pins and should be tied  
together as close to the supply as possible. In addition, these  
supplies should be decoupled as close to the package as possible.  
Microphone: The microphone pin transfers input signal to the on-  
chip preamplifier. A built-in Automatic Gain Control (AGC) circuit  
controls the gain of this preamplifier from –15 to 24dB. An external  
microphone should be AC coupled to this pin via a series capacitor.  
The capacitor value, together with the internal 10 Kresistance on  
this pin, determines the low-frequency cutoff for the ISD2500 series  
passband. See Winbond’s Application Information for additional  
information on low-frequency cutoff calculation.  
MIC  
MIC REF  
AGC  
18  
19  
25  
26  
Microphone Reference: The MIC REF input is the inverting input  
to the microphone preamplifier. This provides a noise-canceling or  
common-mode rejection input to the device when connected to a  
differential microphone.  
: The AGC dynamically adjusts the gain of  
Automatic Gain Control  
the preamplifier to compensate for the wide range of microphone  
input levels. The AGC allows the full range of whispers to loud  
sounds to be recorded with minimal distortion. The “attack” time is  
determined by the time constant of a 5 Kinternal resistance and  
an external capacitor (C2 on the schematic of Figure 5 in section  
11) connected from the AGC pin to VSSA analog ground. The  
“release” time is determined by the time constant of an external  
resistor (R2) and an external capacitor (C2) connected in parallel  
between the AGC pin and VSSA analog ground. Nominal values of  
470 Kand 4.7 µF give satisfactory results in most cases.  
ANA IN  
20  
21  
27  
28  
Analog Input: The analog input transfers analog signal to the chip  
for recording. For microphone inputs, the ANA OUT pin should be  
connected via an external capacitor to the ANA IN pin. This  
capacitor value, together with the 3.0 Kinput impedance of ANA  
IN, is selected to give additional cutoff at the low-frequency end of  
the voice passband. If the desired input is derived from a source  
other than a microphone, the signal can be fed, capacitively  
coupled, into the ANA IN pin directly.  
ANA OUT  
Analog Output: This pin provides the preamplifier output to the  
user. The voltage gain of the preamplifier is determined by the  
voltage level at the AGC pin.  
Publication Release Date: May 2003  
- 7 -  
Revision 1.0  

与ISD2590相关器件

型号 品牌 描述 获取价格 数据表
ISD2590E WINBOND Speech Synthesizer With RCDG, 90s, CMOS, PDSO28, 8 X 13.40 MM, PLASTIC, TSOP1-28

获取价格

ISD2590EY WINBOND 暂无描述

获取价格

ISD2590G WINBOND Speech Synthesizer With RCDG, 93s, CMOS, PDSO28

获取价格

ISD2590P WINBOND Speech Synthesizer With RCDG, 90s, CMOS, PDIP28, 0.600 INCH, PLASTIC, DIP-28

获取价格

ISD2590PRODUCTS ETC

获取价格

ISD2590PY WINBOND Speech Synthesizer With RCDG, 90s, CMOS, PDIP28, 0.600 INCH, LEAD FREE, PLASTIC, DIP-28

获取价格