ISD14B00
PIN NAME
PIN # I / O
FUNCTION
M¯¯7: When Direct Mode is active, low active operation on 7th Message.
Internal pull-up & debounce existed.
E3/M¯¯8
11
I
E3[1] : In Address Mode, End Address Bit 3.
M¯¯8: When Direct Mode is active, low active operation on 8th Message.
Internal pull-up & debounce existed.
VSSP2
SP-
12
13
I
O
Ground: Ground for negative PWM speaker driver.
SP-: Negative signal of the differential Class-D PWM speaker outputs. This
output, together with the SP+, is used to drive an 8Ω speaker directly.
Speaker Power Supply: Power supply for PWM speaker drivers.
Depending on the derivative selected, it could be:
SP+: Positive signal of the differential Class-D PWM speaker outputs. This
output, together with the SP-, is used to drive an 8Ω speaker directly.
Or,
VCCP
SP+
14
15
I
O
AUX out: single-ended voltage output.
VSSP1
AGC
16
17
I
I
Ground: Ground for positive PWM speaker driver.
Automatic Gain Control (AGC): The AGC adjusts the gain of the
preamplifier dynamically to compensate for the wide range of microphone
input levels. The AGC allows the full range of signals to be recorded with
minimal distortion. The AGC is designed to operate with a nominal capacitor
of 4.7 µF connected to this pin.
Connecting this pin to ground (VSSA) provides maximum gain to the
preamplifier circuitry. Conversely, connecting this pin to the power supply
(VCCA) provides minimum gain to the preamplifier circuitry.
MIC+ / AnaIn
18
I
MIC+: Non-inverting input of the differential microphone signal.
AnaIn: When F¯T¯ is selected, the MIC+ input is configured to a single-
ended input with 1Vp-p maximum input amplitude and feed-through to the
speaker outputs.
MIC- / NC
Rosc
19
20
I
I
MIC-: Inverting input of the differential microphone signal. While F¯T¯ is
enabled, MIC- pin is disabled and must be floated.
Oscillator Resistor: Connect an external resistor from this pin to VSSA to
select the internal sampling frequency.
VCCA
¯L¯E¯D¯
21
22
I
O
Analog Power Supply: Power supply for analog circuits.
LED output: During recording, this output is Low. Also, ¯L¯E¯D¯ pulses Low
momentarily at the end of playback.
¯P¯la¯y¯E¯/FMC2
23
I
¯P¯la¯y¯E¯: In Address Mode, low active input, edge-trigger playback from start
to end addresses & toggle on-off. Debounce & internal pull-up existed.
FMC2: When Direct Mode is active, FMC2, together with FMC1 & FMC3,
setup various fixed-message configurations.
¯R¯E¯C¯/¯R¯/P
24
I
¯R¯E¯C¯: In Address Mode, level-hold (after 1 sec holding) or edge-trigger
(toggle on-off), low active, recording from start to end addresses. Debounce
& internal pull-up existed.
Publication Release Date: Jan 19, 2009
- 7 -
Revision 0.30