HV892
2.0
PIN DESCRIPTION
Table 2-1 details the description of pins in HV892.
Refer to Package Type for the location of pins.
TABLE 2-1:
Pin
PIN FUNCTION TABLE
Pin
Description
Number Name
1
2
3
GND1 Ground for the DC–DC converter. Connect GND1 and GND2 close to the IC.
VIN Input voltage. Bypass with a 2.2 µF capacitor to GND1.
SCL Clock for the I2C interface. The HV892 is a Fast mode device (fSCL ≤ 400 kHz).
Serial data for the I2C interface. The HV892 is a write-only device with a single 8-bit command
byte. (Refer to Table 3-1.)
4
SDA
VDD Externally supplied reference voltage for the I2C logic levels. Connect to the I2C bus supply.
GND2 Ground for the IC, except the DC-DC converter. Connect GND1 and GND2 close to the IC.
5
6
7
8
9
OUT2
OUT1
NC
Outputs of the H-bridge driver. The liquid lens connect these two pins. When disabled
(AMP = 00h), both of these outputs are held at ground.
Not connected
High-voltage DC output of the internal boost converter. Connect a 4.7 nF 100V ceramic capacitor
to ground close to the IC.
10
HV
Note 1: Exposed backside pad is at ground potential and should be connected to circuit ground.
2022 Microchip Technology Inc. and its subsidiaries
DS20005712A-page 7