HMC334LP4 / 334LP4E
v03.0410
SiGe WIDEBAND
DOWNCONVERTER, 0.6 - 2.7 GHz
Pin Descriptions
Pin Number
Function
Description
Supply for LO Amplifier.
Interface Schematic
9
Draws approximately 120mA from VSLO.
A 13 Ohm resistor (R1) must be connected
externally between the VSLO supply and the
VccLO pin. See evaluation PCB schematic.
1
VccLO
2, 5, 8, 11,
14, 17, 20, 23
These pins and the ground paddle should be
connected to a high quality RF/DC ground.
GND
LOP
LO Input Port. This pin needs a DC blocking capacitor.
(Typical voltage on this pin will be 1.5 - 1.8V)
3
For single ended applications, this pin should be AC
grounded
4
LON
The pins are not connected internally; however, all data
shown herein was measured with these pins connected to
RF/DC ground externally.
6, 7, 12,
21, 22, 24
N/C
Differential baseband outputs, 200 ohm differential output
impedance. Each port should draw approximately 25mA
from VSIF without LO power and 28mA from VSIF with LO
power on.
9, 10
IFN, IFP
For single-ended 50 Ohm operation, port J2 or J3 should be
shorted to RF/DC ground. See evaluation PCB schematic.
Center tap of the RF transformer. Biased at 2.2V when con-
nected to ground through two 91 ohm resistors.
13, 18
CTRF
Pin to be connected to a high quality RF/DC ground. Also
can be used to drive the RF port differentially if needed.
15
16
GNDRF
RF
50 Ohms impedance can be matched
from 600 - 3000 MHz.
Supply decoupling for the mixer stage.
(Typical voltage on this pin will be 4.8V)
Connect C3 to a high quality RF/DC
ground per evaluation PCB schematic.
19
VccIF
For price, delivery and to place orders: Hittite Microwave Corporation, 20 Alpha Road, Chelmsford, MA 01824
Phone: 978-250-3343 Fax: 978-250-3373 Order On-line at www.hittite.com
Application Support: Phone: 978-250-3343 or apps@hittite.com
9 - 43