HI-3000H, HI-3001H
1Mbps Avionics CAN Transceiver
with High Operating Temperature
March 2020
PIN CONFIGURATIONS (Top Views)
GENERALDESCRIPTION
TXD - 1
GND - 2
VDD - 3
RXD - 4
8 - STB
The HI-3000H is a 1 Mbps Controller Area Network
(CAN) transceiver optimized for use in high temperature
avionics applications. The device is capable of operating
at extended temperature ranges of -55°C to 175°C for
plastic packages and -55°C to 200°C for the ceramic
CERDIP-8 package. It interfaces between a CAN proto-
col controller and the physical wires of the bus in a CAN
network. Differential output amplitude and current drive
capability are specifically enhanced to meet the needs of
long cable runs typical ofavionics applications.
7 - CANH
6 - CANL
5 - SPLIT
HI-3000PSHF
HI-3000CRH
TXD - 1
GND - 2
VDD - 3
RXD - 4
8 - STB
7 - CANH
6 - CANL
5 - VIO
HI-3001PSHF
HI-3001CRH
The HI-3000H supports two modes of operation: Normal
Mode and Standby Mode. The Standby Mode is a very
low-current mode which continues to monitor bus activity
and allows an external controller tomanage wake-up.
8-Pin Plastic SOIC package (Narrow Body)
& 8-Pin Ceramic CERDIP
FEATURES
Superior common-mode receiver performance makes
the device especially suitable for applications where
ground reference voltages may vary from point to point
over long distances along the CAN bus. In addition, the
HI-3000H provides a SPLIT pin to give an output refer-
ence voltage of VDD/2 which can be used for stabilizing
the recessive bus level when the split termination tech-
nique isused toterminate the bus.
· Extended Temperature Ranges -55°C to 175°C (plastic
SOIC-8 package) and -55°C to 200°C (ceramic CERDIP-
8 package)
· Fully compliant with ARINC 825 and ISO 11898-5
standards.
· Signaling rates up to 1Mbit/s.
· Internal VDD/2 voltage source available to stabilize the
recessive bus level if split termination is used (HI-3000H
SPLIT pin).
A TXD dominant time-out feature protects the bus from
being driven into a permanent dominant state (so-called
“babbling idiot”) ifpinTXDbecomes permanently low due
toapplication failure.
· VIO input on HI-3001H allows for direct interfacing with
3.3V controllers.
· Detection of permanent dominant on TXD pin (babbling
idiot protection).
The device also has short circuit protection to +/-58V on
CANH, CANL and SPLIT pins and ESD protection to
+/-6kVon all pins.
· High impedance allows connection of up to 120 nodes.
· Input levels compatible with 3.3V or 5V controllers.
· CANH, CANL and SPLIT pins short-circuit proof to +/-
58V.
The HI-3001H is identical to the HI-3000H except the
SPLIT pin is substituted with a VIO supply voltage pin.
This allows the HI-3001H to interface directly with con-
trollers with 3.3V supply voltages.
· Will not disturb the bus if unpowered.
HOLT INTEGRATED CIRCUITS
www.holtic.com
(DS3000H Rev. A)
03/20