Datasheet > HCEM200U

HCEM200U

更新时间： 2022-02-26 13:20:18

品牌	Logo	应用领域
SENSORTECHNICS		/
页数	文件大小	规格书
11页	182K
描述
Miniature amplified pressure sensors

阅读下载

获取价格

数据手册

如果您发现信息不准确，欢迎纠错

HCEM200U 数据手册

HCE Series

Miniature amplified pressure sensors

SPI - SERIAL PERIPHERAL INTERFACE

Introduction

In general the HCE series supports all combinations of

clock phase (CPHA) and polarity (CPOL). By default it is

programmed to CPHA = 0 and CPOL = 0, which means

that data transmission starts with the rising first clock edge

(see Fig 1).

The HCE is capable to generate a digital output signal.

The device runs a cyclic program, which will store a corrected

sensor value with 14 bit resolution about every 500 µs within

the output registers of the internalASIC. This cyclic program

runs independent from the bus communication. In order to

use the pressure sensor for digital signal readout, it should

be connected to a SPI Master device.

Slave select

The falling edge of the SS line indicates the beginning of

the transfer. Additionally the SS line must not be negated

and reasserted between the three bytes to be transmitted.

SPI specifies four signals: The clock (CLK) is generated by

the master and input to all slaves. MOSI carries data from

master to slave. MISO carries data from slave back to

master. A slave select line (SS) allows individual selection

of a slave device.

Data operation

The MOSI line should always be set to high level. So there

is no data transmission from master to slave. Because of

internal configuration the slave will answer the first byte

with an FFxh. The second and third byte contain the 15 bit

pressure information (see Fig. 2).

SPI Modes

A pair of parameters called clock polarity (CPOL) and clock

phase (CPHA) determine the edges of the clock signal on

which the data are driven and sampled. Each of the two

parameters has two possible states, which allows for four

possible combinations, all of which are incompatible with

one another.

For further information please refer to

First Sensor's SPI bus application note

SCK cycle

SCK

(CPOL=0)

MSB

LSB

MOSI

MISO

MSB

Sampling

Fig. 1: Example of a standard 1 byte SPI data transfer for CPHA=0 and CPOL=0

Data Byte 1

Data Byte 2

Data Byte 3

MOSI

MISO

X P14 P13 P12 P11 P10 P9 P8 P7 P6 P5 P4 P3 P2 P1 P0

Relevant data

Fig. 2: 3 byte data stream between HCE sensor and master containing the pressure value as a 15 bit information

E / 11652 / F

5/11

www.first-sensor.com

www.sensortechnics.com

1 2 3 456 7 8...11

下载PDF

与HCEM200U相关器件

型号	品牌	描述	获取价格	数据表
HCEM500B	SENSORTECHNICS	Miniature amplified pressure sensors	获取价格
HCEM500U	SENSORTECHNICS	Miniature amplified pressure sensors	获取价格
HC-EVO-B10-BFDC-PLRBK	PHOENIX	Connector Accessory,	获取价格
HC-EVO-B16-BFDC-PLRBK	PHOENIX	Connector Accessory,	获取价格
HCF	SCHURTER	Solid State	获取价格
HCF0053	ETC	Consumer IC	获取价格