PISCES II DC/DC CONVERTERS
48V Input – 1.2VDC – 60A Output
POWER PRODUCTS
G2PW1V260
CoolConverter™
Protection and Control
Trim-up
Thermal Shutdown
The printed circuit board temperature is measured using a
semiconductor sensor. If the maximum rated temperature
is exceeded, the converter is latched off. To re-enable the
converter requires cycling the ON/OFF pin or power to the
converter. If non-latching is required, consult factory.
1.2ꢀ(100+∆%)
0.62∆%
(100+2∆%)
∆%
_
RTRIM-UP
=
5.11kΩ
ꢀ
{
}
ꢀ
1.2V Trim-up
1000
100
10
Control Options
As the behavior of the circuit is determined by firmware in the
microcontroller, specific requirements, such as:
•
•
•
non-latching thermal protection
custom valid input voltage range
controlled delay from initiating an ON/OFF signal for
power sequencing
can be accomplished with no change to hardware. The
standard behavior was chosen based on system design
experience, but customers may have their own requirements.
Please contact Bel Power for any special needs.
0
2
3
4
5
6
7
8
9
10
1
Increase in Output Voltage (%)
Remote Sense
The output voltage is regulated at the point where the
sense pins connect to the power output pins. Total sense
compensation should not exceed 0.4V or 10% of Vout,
whichever is greater.
Trim-down
Safety
An external input fuse must always be used to meet these
safety requirements.
100ꢀ
_
RTRIM-DOWN
=
2
5.11kΩ
ꢀ
ꢀ
∆%
{ }
External Output Trimming
Trim-down
+ Sense
1000
100
10
Trim
– Sense
Trim
To trim the output voltage higher, connect the required trim
resistor from the Trim pin to the +Sense pin. To trim the output
voltage lower, connect the required trim resistor from the Trim
pin to the –Sense pin.
0
2
3
4
5
6
7
8
9
10
1
Decrease in Output Voltage (%)
©2006 Bel Fuse Inc. Specifications subject to change without notice. 11.06
Bel Power Inc. 155 Flanders Road, Westborough, MA 01581 • Tel 508-870-9775 • Fax 508-870-9796 • www.belpower.com
page 5