Absolute encoders - SSI
Hollow shaft max. ø14 mm
Optical multiturn encoders 14 bit ST / 12 bit MT
G0M2H - SSI
Terminal significance
Terminal assignment
UB
Encoder voltage supply.
G0M2H
GND
Data+
Encoder ground connection relating to UB.
Connector Core colour Assignment
Positive, serial data output of differential
linedriver.
Pin 1
Pin 2
Pin 3
Pin 4
Pin 5
Pin 6
Pin 7
Pin 8
Pin 9
Pin 10
Pin 11
Pin 12
brown
black
blue
UB
GND
Data-
Negative, serial data output of differential
linedriver.
Clock+
Data+
Zero setting
Data-
beige
green
yellow
violet
Clock+
Positive SSI clock input.
Clock+ together with clock- forms a current
loop. A current of approx. 7 mA towards
clock+ input means logic 1 in positive logic.
Clock-
Clock-
Negative SSI clock input.
brown/yellow DATAVALID
pink UP/DOWN
black/yellow DATAVALID MT
Clock- together with clock+ forms a current
loop. A current of approx. 7 mA towards
clock- input means logic 0 in positive logic.
–
–
–
–
Zero setting
Input for setting a zero point anywhere
within the programmed encoder resolution.
The zero setting operation is triggered by a
High impulse and has to be in line with the
selected direction of rotation (UP/DOWN).
Connect to GND after setting operation for
maximum interference immunity. Impulse
duration >100 ms.
G0M2H with inremental tracks
Connector Core colour Assignment
Pin 1
Pin 2
Pin 3
Pin 4
Pin 5
Pin 6
Pin 7
Pin 8
Pin 9
Pin 10
Pin 11
Pin 12
brown
white
blue
UB
GND
DATAVALID
Diagnostic output.
Clock+
An error warning is given at level Low.
Important: Interferences must be filtered by
the downstram electronics.
green
grey
Data+
Zero setting
Data-
yellow
red
DATAVALID MT Diagnostic output for monitoring the
multiturn sensor voltage supply. Upon
Clock-
dropping below a defined voltage level the
DV MT output is switched to Low.
red/blue
pink
Track B inv.
UP/DOWN
Track a inv.
Track A
Track B
UP/DOWN
UP/DOWN counting direction input.
This input is standard on High. UP/DOWN
means ascending output data with clock-
wise shaft rotation when looking at flange.
UP/DOWN-Low means ascending values
with counterclockwise shaft rotation when
looking at flange.
violet
black
grey/pink
Please use cores twisted in pairs (for
example clock+ / clock-) for extensi-
on cables of more than 10 m length.
8
1
9
Incremental
Outputs
Incremental tracks A 90° B and inverted.
10
12
2
3
7
6
11
4
5
www.baumerivo.com
3