DATA SHEET
www.onsemi.com
Motion SPM) 3 Series
FNB33060T
FNB33060T is an advanced Motion SPM 3 module providing
a fully−featured, high−performance inverter output stage for AC
Induction, BLDC, and PMSM motors. These modules integrate
optimized gate drive of the built−in IGBTs to minimize EMI
and losses, while also providing multiple on−module protection
features including under−voltage lockouts, over−current shutdown,
thermal monitoring of drive IC, and fault reporting. The built−in,
high−speed HVIC requires only a single supply voltage and translates
the incoming logic−level gate inputs to the high−voltage, high−current
drive signals required to properly drive the module’s internal IGBTs.
Separate negative IGBT terminals are available for each phase
to support the widest variety of control algorithms.
3D Package Drawing
(Click to Activate 3D Content)
SPMCA−027 / PDD STD, SPM27−CA, DBC TYPE
CASE MODFJ
Features
MARKING DIAGRAM
• 600 V − 30 A 3−Phase IGBT Inverter with Integral Gate Drivers
and Protection
• Low−Loss, Short−Circuit Rated IGBTs
• Very Low Thermal Resistance Using Al O DBC Substrate
&Y
FNB33060T
&Z&K &3
EK&Z&K&3
2
3
• Built−In Bootstrap Diodes and Dedicated Vs Pins Simplify
PCB Layout
• Separate Open−Emitter Pins from Low−Side IGBTs for
Three−Phase Current Sensing
• Single−Grounded Power Supply
• LVIC Temperature−Sensing Built−In for Temperature
Monitoring
$Y
&Z
&K
&3
= onsemi Logo
= Assembly Plant Code
= 2−Digits Lot Run Traceability Code
= 3−Digit Date Code
FNB33060T = Specific Device Code
• Isolation Rating: 2500 V / min
rms
• This Device is Pb−Free and Halide Free
ORDERING INFORMATION
See detailed ordering and shipping information on page 12 of
this data sheet.
Applications
• Motion Control − Home Appliance / Industrial Motor
Integrated Power Functions
• 600 V − 30 A IGBT Inverter for Three−phase DC / AC Power
Conversion (Please refer to Figure 2)
Related Resources
®
• AN−9088 − Motion SPM 3 V6 Series
Users Guide
• AN−9086 − SPM 3 Package Mounting
Integrated Drive, Protection and System Control Functions
• For Inverter High−side IGBTs: gate drive circuit, high−voltage
isolated high−speed level shifting control circuit Under−Voltage
Lock−Out Protection (UVLO)
Guide
(Note: Available bootstrap circuit example is given in Figures 5
and 15)
• For Inverter Low−side IGBTs: gate drive circuit, Short−Circuit
Protection (SCP) control supply circuit Under−Voltage Lock−Out
protection (UVLO)
• Fault Signaling: corresponding to UVLO (low−side supply) and SC
faults
• Input Interface: Active−HIGH interface, works with 3.3 / 5 V logic,
Schmitt−trigger input
© Semiconductor Components Industries, LLC, 2016
1
Publication Order Number:
October, 2022 − Rev. 2
FNB33060T/D