50-60W
OPEN-FRAME SWITCHING POWER SUPPLIES
FLU2-50/FLU3-50/FLU1-60 SERIES
A. Dimensions shown are in inches.
B. Tolerances = 0.00 0.01 inch.
0.000 0.005 inch.
C. P1 input connectors are Molex 26-60-4030. The mating connector
combines Molex housing 43061-0003 and crimp terminal 08-70-1030.
D. P2 output connectors:
FLU1-60 series—Molex 26-60-4080
FLU2-50 series—Molex 26-60-4060
FLU3-50 series, Models 1, 2, 3—Molex 26-60-4060
FLU3-50 series, Models 4, 5—Molex 26-60-4100
Mating connector housings:
FLU1-60 series—Molex 43061-0008.
FLU2-50 series—Molex 43061-0006.
FLU3-50 series, models 1, 2, 3—Molex 43061-0006.
FLU3-50 series, models 4, 5—Molex 43061-0010.
Crimp terminals:
All models—Molex 08-70-1030.
Pin-Out
FLU3-50
FLU3-50
Pin
FLU2-50 Models 1-3 Models 4-5 FLU1-60
1
2
3
4
5
6
7
8
9
V2
V1
V2
V1
V1
+V2(ISO) +Sense§
- V2(ISO)
+V1(ISO)
+V1(ISO)
+V1(ISO)
- V1(ISO)
- V1(ISO)
- V1(ISO)
- V3(ISO)
+V3(ISO)
V1
V1
V1
Common
Common
N/C
Common
Common
V3
V1
Return
Return
Return
-Sense§
N/A
N/A
N/A
N/A
N/A
N/A
N/A
10
N/A
N/A
N/A
§
If sense terminals are not used, tie together Pins 1 and 2 and tie
together Pins 7 and 8.
DC60 SERIES
A. Dimensions shown are in inches.
B. Tolerances = 0.00 0.01 inch.
0.000 0.005 inch.
C. Under-voltage shutdown on the DC60 series is activated
at 10% below low line, typical. Over-voltage shutdown is
typically activated at 10% above high line.
D. A TTL HIGH signal at the external shutdown pin of the
DC60 series disables the unit.
E. External frequency synchronization of the DC60 series
requires a 2.8V positive pulse (>9.1 µs) at the external
synch pin.
Pin-Out
Terminal
DC60
1
2
3
4
5
6
+Sense§
V1
V1
Return
Return
-Sense§
§
If Sense terminals are not used, tie
together Terminals 1 and 2 and tie
together Terminals 5 and 6.
POWER GENERAL 152 Will Drive · Canton, MA 02021 USA · Phone 781-828-6216 · Fax 781-830-1155 · Email power@nidecpg.com
15