Pl tronics, Inc.
.
19013 36th Ave. W, Suite H Lynnwood, WA 98036 USA
Manufacturer of High Quality Frequency Control Products
ED1145M ECL Series
Full Size Metal Thru-Hole ECL Oscillator
Differential or NonDifferential ECL Output without Enable/Disable
–
10.00 MHz 170.00 MHz
Consult factory for higher frequencies
Standard Specifications
Overall Frequency Stability
EC1145M:± 50 PPM, EC1144M: ± 25 PPM, EC1120M: ± 20 PPM over Operating Temp. Range
°
Operating Temperature Range 0 to +80 C is standard, but can be extended to - 40 to +85°C for certain frequencies
Supply Voltage (Vee)
Supply Current (Icc)
Jitter
- 5.2 volts
³
60 to 70 mA typical, 90 mA maximum for 70 MHz. For < 70 MHz, consult factory
1 pS RMS maximum, from 12 kHz to 20 MHz from carrier for ³ 70 MHz. For < 70 MHz, consult factory
Output must be terminated into 50 ohms to (Vee - 2.0 V). See Test Circuit 5 (with no E/D)
Output Load
Symmetry
Tr & Tf
Logic “1”
45/55% to 55/45% at 50% of Vee level (see Waveform 2)
³
1.0 nS max (20 to 80%) for 70 MHz. For < 70 MHz, consult factory
ECL Output Waveform
Vcc - 1.025 volts minimum
Vcc - 1.620 volts maximum
Logic “0”
Part Numbering Guide
Portions of the part number that appear after the frequency may not be marked on part (C of C provided)
ED11 45 M E - 70.0M - XXX (Internal Code or blank)
Packaging
Tube
Model
Frequency in MHz
EC = ECL NonDifferential
Special Specifications (choose all that apply)
ED = ECL Differential
°
E: Extended Operating Temperature Range (- 40 to +85 C)
F: 47.5 /52.5% Symmetry at 50% of Vcc
Frequency Stability
45 = ± 50 PPM
44 = ± 25 PPM
20 = ± 20 PPM
Consult factory for available frequencies and specs. Not all options available for all frequencies. A special part number may be assigned.
Frequency Stability is inclusive of frequency shifts due to calibration, temperature, supply voltage, shock, vibration and load
Mechanical: inches (mm)
not to scale
Solder Pads
Due to part size and factory abilities, part marking may vary from lot to lot and may contain our part number or an internal code.
.200 (5.08) MAX
.807 (20.5) MAX
PLETRONICS
.600 (15.24)
14
.031 (0.8)
GND
OUT 2
8
7
.020
(.51)
1
Vee
EC Pin 1 = GND
ED Pin 1 = Q OUT
.250 (6.35) MAX
July 2002
(425) 776 -1880, Fax: (425) 776-2760, ple-sales@pletronics.com, www.pletronics.com
3
Pl tronics, Inc.