DS80C410/DS80C411
Network Microcontrollers with
Ethernet and CAN
www.maxim-ic.com
GENERAL DESCRIPTION
FEATURES
Cꢀ High-Performance Architecture
Single 8051 Instruction Cycle in 54ns
DC to 75MHz Clock Rate
The DS80C410/DS80C411 network microcontrollers offer
the highest integration available in an 8051 device.
Peripherals include a 10/100 Ethernet MAC, three serial
ports, an optional CAN 2.0B controller, 1-Wire® Master,
and 64 I/O pins. The DS80C410 and DS80C411 also
include 64kBytes internal SRAM for user application
storage and network stack.
Flat 16MB Address Space
Four Data Pointers with Auto-Increment/
Decrement and Select-Accelerate Data Movement
16/32-Bit Math Accelerator
Cꢀ Multitiered Networking and I/O
10/100 Ethernet Media Access Controller (MAC)
Optional CAN 2.0B Controller
To enable access to the network, a full application-
accessible TCP IPv4/6 network stack and OS are provided
in the ROM. The network stack supports up to 32
simultaneous TCP connections and can transfer up to
5Mbps through the Ethernet MAC. Its maximum system-
clock frequency of 75MHz results in a minimum instruction
cycle time of 54ns. Access to large program or data
memory areas is simplified with a 24-bit addressing
scheme that supports up to 16MB of contiguous memory.
To accelerate data transfers between the microcontroller
and memory, the DS80C410 and DS80C411 provide four
data pointers, each of which can be configured to
automatically increment or decrement upon execution of
certain data pointer-related instructions. High-speed shift,
normalization, accumulate functions and 32-bit/16-bit
multiply and divide operations are optimized by the
DS80C410/DS80C411 hardware math accelerator.
1-Wire Net Controller
Three Full-Duplex Hardware Serial Ports
Up to Eight Bidirectional 8-Bit Ports (64 Digital I/O Pins)
Cꢀ Robust ROM Firmware
Supports Network Boot Over Ethernet Using DHCP and
TFTP
Full, Application-Accessible TCP/IP Network Stack
Supports IPv4 and IPv6
Implements UDP, TCP, DHCP, ICMP, and IGMP
Preemptive, Priority-Based Task Scheduler
MAC Address can Optionally be Acquired from IEEE-
Registered DS2502-E48
Cꢀ 10/100 Ethernet Mac
Flexible IEEE 802.3 MII (10/100Mbps) and ENDEC
(10Mbps) Interfaces Allow Selection of PHY
Low-Power Operation
The High-Speed Microcontroller User’s Guide and the High-Speed
Microcontroller User’s Guide: Network Microcontroller Supplement
should be used in conjunction with this data sheet. Download
both at: www.maxim-ic.com/user_guides.
Ultra-Low-Power Sleep Mode with Magic Packet®
and Wake-Up Frame Detection
8kB On-Chip Tx/Rx Packet Data Memory with Buffer
Control Unit Reduces Load on CPU
Half- or Full-Duplex Operation with Flow Control
Multicast/Broadcast Address Filtering with VLAN
Support
APPLICATIONS
Data Converters (Serial-to-
Ethernet, CAN-to-
Ethernet)
Industrial Control/Automation
Cꢀ Full-Function CAN 2.0B Controller
15 Message Centers
Environmental Monitoring
Network Sensors
Vending
Supports Standard (11-Bit) and Extended (29-Bit)
Identifiers and Global Masks
Remote Data-Collection
Equipment
Media Byte Filtering to Support DeviceNet™, SDS, and
Higher Layer CAN Protocols
Home/Office Automation
Transaction/Payment
Auto-Baud Mode and SIESTA Low-Power Mode
Cꢀ Integrated Primary System Logic
16 Total Interrupt Sources with Six External
Four 16-Bit Timer/Counters
Terminals
ORDERING INFORMATION
2x/4x Clock Multiplier Reduces Electromagnetic
Interference (EMI)
PART
TEMP RANGE
-40°C to +85°C
-40°C to +85°C
PIN-PACKAGE
100 LQFP
DS80C410-FNY
DS80C411-FNY
Programmable Watchdog Timer
Oscillator-Fail Detection
100 LQFP
Programmable IrDA Clock
Features continued on page 35.
1-Wire is a registered trademark of Dallas Semiconductor Corp.
Magic Packet is a registered trademark of Advanced Micro
Devices, Inc.
Pin Configuration appears at end of data sheet.
Selector Guide appears at end of data sheet.
DeviceNet is a trademark of Open DeviceNet Vendor Association, Inc.
Note: Some revisions of this device may incorporate deviations from published specifications known as errata. Multiple revisions of any device
may be simultaneously available through various sales channels. For information about device errata, click here: www.maxim-ic.com/errata.
1 of 102
REV: 010705