DP83822HF, DP83822IF, DP83822H, DP83822I
www.ti.com.cn
ZHCSFD6F –JULY 2016 –REVISED JUNE 2021
表6-1. Pin Functions (continued)
PIN
NAME
TYPE(1)
DESCRIPTION
NO.
MII Mode: COL pin can be used to drive an LED when operating in Full-
Duplex mode. Register access is required for LED configuration.
RMII Mode: This pin can be used as an LED when using register access.
RGMII Mode:This pin can be used as an LED when using register
access.
COL / GPIO2
29
I/O, S, PU
GPIO2: This pin can be used as a GPIO when using register access.
MII Mode: RX_D3 will remain as RX_D3 because it is required for MII
mode.
RMII Mode: RX_D3 pin can be configured to drive an LED. Register
access is required for LED configuration.
RX_D3 / GPIO3
1
I/O, S-PD
RGMII Mode:RX_D3 will remain as RX_D3 because it is required for
RGMII mode.
GPIO3: This pin can be used as a GPIO when using register access.
MEDIA DEPENDENT INTERFACE
TD_M
11
12
9
Differential Transmit Output (PMD): These differential outputs can be
automatically configured to either 10BASE-Te, 100BASE-TX, or
100BASE-FX signaling or forced into a specific signaling mode.
A
A
TD_P
RD_M
RD_P
Differential Receive Input (PMD): These differential inputs are
automatically configured to accept either 10BASE-Te, 100BASE-TX, or
100BASE-FX signaling or forced into a specific signaling mode.
10
POWER AND GROUND PINS
VDDIO
AVD
21
14
P
P
I/O Supply: 3.3 V, 2.5 V, or 1.8 V
Analog Supply: 3.3 V or 1.8 V
Ground
Ground
Pad
GND
P
I
Bias Resistor Connection. A 4.87-kΩ±1% resistor must be connected
from RBIAS to GND.
RBIAS
16
OTHER PINS
NC
NC
13
15
NC
NC
Leave Floating
Leave Floating
This pin can be left floating when not in used. External Pull resistors are
required when LED is connected to this pin.
LED_1 / GPIO1
24
I/O, S-PD
(1) The definitions below define the functionality of the I/O cells for each pin.
•
•
•
•
•
•
Type: I - Input
Type: O - Output
Type: I/O - Input/Output
Type OD - Open Drain
Type: PD, PU - Internal Pulldown/Pullup
Type: S-PU, S-PD - Strapping Pin (All strap pins have weak internal pullups or pulldowns. If the default strap value is needed to be
changed then an external 2.2-kΩresistor should be used)
Copyright © 2022 Texas Instruments Incorporated
Submit Document Feedback
7
Product Folder Links: DP83822HF DP83822IF DP83822H DP83822I