CYPD2803
EZ-PD™ CMG2 USB Type-C EMCA controller
General description
EZ-PD™ CMG2 is a dedicated USB Type-C EMCA controller that complies with the USB Type-C and Power Delivery
(PD) standards for electronically marked Type-C thunderbolt and non-thunderbolt passive cable applications.
EZ-PD™ CMG2 integrates a complete Type-C transceiver including the RA termination resistors on the VCONN pins
and VBUS short circuit protection on both VCONN and CC pins. EZ-PD™ CMG2 also includes 47 bytes of storage
for configuration of vendor, device, and cable specific configuration data. EZ-PD™ CMG2 is targeted for passive
EMCA implementations with either one or two e-marker chips on the cable.
Features
• Type-C support and USB-PD support
- Supports USB Power Delivery specification revision 3.1, v1.4 and USB Type-C Specification revision 2.1
(including support for the revised minimum VCONN operating voltage of 3 V)
- Supports USB4, TBT4 and extended power range (EPR) PD protocol
- Integrated high-voltage protection on CC, VCONN1, and VCONN2 pins to protect against accidental shorts to
the VBUS pin on the Type-C connector up to 54 V
- 47-byte storage programmable over Type-C interface for storing vendor, device, and cable specific
configuration data
- Termination resistor RA on VCONN1 and VCONN2
- Supports RA weakening to reduce power consumption
- Supports electronically marked passive cable implementations with one or two controllers
- Supports up to 240W (48V/5A) of power
• Clocks and oscillators
• Integrated oscillator eliminating the need for external clock
• Power
- 2.7 V to 5.5 V operation
- Sleep: 1.7 mA typical
• System-level electrostatic discharge (ESD) protection
- On CC, VCONN1, and VCONN2 pins
- ± 8 kV contact discharge and ±15 kV air gap discharge based on IEC61000-4-2 level 4C
• Package
- 9-ball WLCSP
- Supports industrial temperature range (–40°C to +85°C)
Datasheet
www.infineon.com
Please read the Important Notice and Warnings at the end of this document
page 1
002-36202 Rev. *C
2023-08-04