BQ51013B-Q1
ZHCSM89 –JULY 2021
www.ti.com.cn
表7-1. Pin Functions (continued)
PIN
I/O
DESCRIPTION
NAME
NO.
Programming pin for the over current limit. The total resistance from ILIM to GND (RILIM) sets the current limit.
The schematic shown in 图10-1 illustrates the RILIM as R1 + RFOD. Details can be found in 节8.5 and 图10-1.
ILIM
12
I/O
O
OUT
4
Output pin, delivers power to the load.
Power ground
PGND
1, 20
Filter capacitor for the internal synchronous rectifier. Connect a ceramic capacitor to PGND. Depending on the
power levels, the value may be 4.7 μF to 22 μF.
RECT
18
O
Dual function pin: Temperature Sense (TS) and Control (CTRL) pin functionality.
For the TS functionality connect TS/CTRL to ground through a Negative Temperature Coefficient (NTC)
resistor. If an NTC function is not desired, connect to PGND with a 10-kΩresistor. See 节9.3.13 for more
details.
TS/CTRL
13
I
For the CTRL functionality pull below VCTRL-Low or pull above VCTRL-High to send an End Power Transfer
Packet. See 表9-4 for more details.
PAD
The exposed thermal pad should be connected to ground (PGND)
—
—
8 Specifications
8.1 Absolute Maximum Ratings
over operating free-air temperature range (unless otherwise noted)(1) (2)
MIN
MAX
UNIT
AC1, AC2
20
–0.8
RECT, COMM1, COMM2, OUT, CHG, CLAMP1,
CLAMP2
20
–0.3
Input voltage
V
AD, AD-EN
30
26
7
–0.3
–0.3
–0.3
BOOT1, BOOT2
EN1, EN2(3), FOD, TS/CTRL, ILIM
Input current
AC1, AC2
OUT
2
A(RMS)
Output current
1.5
15
1
A
mA
A
CHG
Output sink current
COMM1, COMM2
Junction temperature, TJ
Storage temperature, Tstg
°C
°C
150
150
–40
–65
(1) All voltages are with respect to the VSS terminal, unless otherwise noted.
(2) Stresses beyond those listed under Absolute Maximum Ratings may cause permanent damage to the device. These are stress ratings
only, and functional operation of the device at these or any other conditions beyond those indicated under Recommended Operating
Conditions is not implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.
(3) If EN1 or EN2 are subject to fast transient (>10V/10ns), current limiting resistors (1k to 10k ohms) should be added.
8.2 ESD Ratings
VALUE
±2000
±500
UNIT
Human body model (HBM), per AEC Q100-002(1)
Charged device model (CDM), per AEC Q100-011
V(ESD)
Electrostatic discharge
V
(1) AEC Q100-002 indicates that HBM stressing must be in accordance with the ANSI/ESDA/JEDEC JS-001 specification.
8.3 Recommended Operating Conditions
over operating free-air temperature range (unless otherwise noted)
MIN MAX
UNIT
VRECT Voltage
RECT
4
7
V
Copyright © 2023 Texas Instruments Incorporated
English Data Sheet: SLUSEE3
6
Submit Document Feedback
Product Folder Links: BQ51013B-Q1