MKP 338 2 X2
Interference Suppression Film Capacitors
MKP Radial Potted Type
Vishay BCcomponents
SUB-CLAUSE NUMBER AND
TEST
CONDITIONS
PERFORMANCE REQUIREMENTS
4.12.3 Final measurements
Visual examination
No visible damage
Legible marking
Capacitance
¦ΔC/C¦ ≤ 5 % of the value measured in 4.12.1.
Increase of tan δ:
Tangent of loss angle
≤ 0. 008 for: C ≤ 1 µF or
≤ 0. 005 for: C > 1 µF
Compared to values measured in 4.12.1.
No permanent breakdown or flash-over
Voltage proof
1350 Vdc; 1 min between term.
Insulation resistance
≥ 50 % of values specified in section “Insulation
Resistance” of this specification
SUB-GROUP C3
4.13.1 Initial measurements
Capacitance
Tangent of loss angle:
For C ≤ 1 µF at 10 kHz
For C > 1 µF at 1 kHz
4.13
4.14
Impulse voltage
Endurance
3 successive impulses, full wave, peak voltage:
X2: 2.5 kV for C ≤ 1 µF
No selfhealing breakdowns or flashover
X2: 2.5 kV/√C for C > 1 µF
Max.24 pulses
Duration: 1000 h
1.25 x URac at 110 °C
Once in every hour the voltage is increased to
1000 V (RMS) for 0.1 s via resistor of 47 Ω 5 %
4.14.7 Final measurements
Visual examination
No visible damage
Legible marking
Capacitance
¦ΔC/C¦ ≤ 10 % compared to values measured in
4.13.1.
Tangent of loss angle
Increase of tan δ:
≤ 0.008 for: C ≤ 1 µF or
≤ 0.005 for: C > 1 µF
Compared to values measured in 4.13.1.
Voltage proof
No permanent breakdown or flash-over
1350 Vdc; 1 min between
terminations.
2120 Vac; 1 min between
terminations and case.
Insulation resistance
≥ 50 % of values specified in section “Insulation
Resistance” of this specification
www.vishay.com
161
For technical questions, contact: rfi@vishay.com
Document Number: 28119
Revision: 16-Jul-09