5秒后页面跳转
ATA5530H-232-TAQY PDF预览

ATA5530H-232-TAQY

更新时间: 2024-01-22 06:49:06
品牌 Logo 应用领域
爱特美尔 - ATMEL ATM异步传输模式电信光电二极管电信集成电路
页数 文件大小 规格书
11页 241K
描述
Telecom Circuit, 1-Func, CMOS, PDSO8, LEAD FREE, SO-8

ATA5530H-232-TAQY 技术参数

是否Rohs认证: 符合生命周期:Obsolete
零件包装代码:SOIC包装说明:LEAD FREE, SO-8
针数:8Reach Compliance Code:unknown
HTS代码:8542.39.00.01风险等级:5.84
JESD-30 代码:R-PDSO-G8JESD-609代码:e3
长度:4.925 mm湿度敏感等级:1
负电源额定电压:-2 V功能数量:1
端子数量:8最高工作温度:125 °C
最低工作温度:-40 °C封装主体材料:PLASTIC/EPOXY
封装代码:SOP封装等效代码:SOP8,.25
封装形状:RECTANGULAR封装形式:SMALL OUTLINE
峰值回流温度(摄氏度):260电源:3 V
认证状态:Not Qualified子类别:Other Telecom ICs
标称供电电压:3 V表面贴装:YES
技术:CMOS电信集成电路类型:TELECOM CIRCUIT
温度等级:AUTOMOTIVE端子面层:Matte Tin (Sn)
端子形式:GULL WING端子节距:1.27 mm
端子位置:DUAL处于峰值回流温度下的最长时间:40
宽度:3.8 mmBase Number Matches:1

ATA5530H-232-TAQY 数据手册

 浏览型号ATA5530H-232-TAQY的Datasheet PDF文件第1页浏览型号ATA5530H-232-TAQY的Datasheet PDF文件第2页浏览型号ATA5530H-232-TAQY的Datasheet PDF文件第3页浏览型号ATA5530H-232-TAQY的Datasheet PDF文件第5页浏览型号ATA5530H-232-TAQY的Datasheet PDF文件第6页浏览型号ATA5530H-232-TAQY的Datasheet PDF文件第7页 
4. Functional Description  
4.1  
Read Operation  
After power up, once the e5530 has detected the incoming RF field, the IC continuously trans-  
mits the identification code as long as the RF signal is applied. The transition from the last bit to  
bit 1 of the next sequence occurs without interruption. Data is transmitted by damping the incom-  
ing RF signal by an internal load. These load changes are detected by the reader station.  
Different kinds of modulation and bitrates are optionally available.  
4.2  
4.3  
Rectifier  
For internal power supply, an on-chip bridge rectifier is used which consists of two diodes and  
two n-channel transistors. A Zener diode, which protects the circuit against overvoltage on the  
coil inputs, and a smoothing capacitor for the internal supply are also provided.  
Damping Load  
Incoming RF will be damped by the power consumption of the IC itself and by an internal load,  
which is controlled by the modulator. The loads are p-channel transistors connected between  
V
DD and the coil inputs.  
The IDIC includes mask options for the load circuit: single-side, double-side and alternate-side  
modulation.  
There are four modulation methods available which can be selected by fuses. The  
corresponding timing diagram is shown in Figure 4-1 on page 5.  
4.4  
4.5  
FSK Modulation  
Logical data “1” and “0” are represented as two different frequencies of damping. The frequency  
for “1” is RF divided by 10, a “0” divides RF by 8.  
PSK Modulation  
The external coil is damped with a carrier frequency of RF/2. A logical “1” causes (at the end of  
the bit period) a 180° phase shift on the carrier frequency, while a logical “0” causes no phase  
shift.  
4.6  
4.7  
Biphase Modulation  
Logical “1” produces a signal which is the same as the internal bitclock. A logical “0” produces no  
signal change in the middle of the bit period.  
Manchester Modulation  
A logical “1” causes a rising edge in the middle of a bit period (i.e., switch damping off), while a  
logical “0” causes a falling edge (i.e., switch damping on).  
A combination of Biphase- and FSK-modulation is also optionally available. The available com-  
binations between the modulation types and the bitrates are shown in Table 4-1 on page 5  
“Transmission Options”.  
4
e5530  
4508C–RFID–08/05  

与ATA5530H-232-TAQY相关器件

型号 品牌 描述 获取价格 数据表
ATA5530H-ZZZ-TAQY ATMEL Telecom Circuit, 1-Func, CMOS, PDSO8, LEAD FREE, SO-8

获取价格

ATA5551 ATMEL High Performance, Low Power Atmel AVR 8-bit Microcontroller Advanced RISC Architecture

获取价格

ATA5551M-PP ATMEL Telecom Circuit

获取价格

ATA5551M-PPMY MICROCHIP IC ID R/W TRANSPONDER PLASTIC

获取价格

ATA5557 ATMEL High Performance, Low Power Atmel AVR 8-bit Microcontroller Advanced RISC Architecture

获取价格

ATA5558 ATMEL 1 kbit R/W IDIC with Deterministic Anticollision

获取价格