AT27C080
Block Diagram
Absolute Maximum Ratings*
*NOTICE:
Stresses beyond those listed under “Absolute
Maximum Ratings” may cause permanent
damage to the device. This is a stress rating
only and functional operation of the device at
these or any other conditions beyond those
indicated in the operational sections of this
specification is not implied. Exposure to abso-
lute maximum rating conditions for extended
periods may affect device reliability.
Temperature Under Bias ...................-55°C to +125°C
Storage Temperature.........................-65°C to +150°C
Voltage on Any Pin with
Respect to Ground ............................-2.0V to +7.0V(1)
Voltage on A9 with
Respect to Ground .........................-2.0V to +14.0V(1)
Note:
1. Minimum voltage is -0.6V DC which may
undershoot to -2.0V for pulses of less than 20
VPP Supply Voltage with
Respect to Ground ..........................-2.0V to +14.0V(1)
ns. Maximum output pin voltage is VCC
+
0.75V DC which may overshoot to +7.0V for
pulses of less than 20 ns.
Integrated UV Erase Dose................ 7258 W•sec/cm2
Operating Modes
Mode/Pin
CE
OE/VPP
VIL
Ai
Outputs
DOUT
Read
VIL
X
Ai
Output Disable
Standby
VIH
X(1)
High Z
High Z
DIN
VIH
VIL
VIL
VIH
X
X
Rapid Program(2)
VPP
VIL
Ai
Ai
PGM Verify
DOUT
PGM Inhibit
VPP
X
High Z
(3)
A9 = VH
Product Identification(4)
VIL
VIL
A0 = VIH or VIL Identification Code
A1 - A19 = VIL
Notes: 1. X can be VIL or VIH.
2. Refer to Programming Characteristics.
3. VH = 12.0 ± 0.5V.
4. Two identifier bytes may be selected. All Ai inputs are held low (VIL), except A9 which is set to VH and A0 which is toggled
low (VIL) to select the Manufacturer’s Identification byte and high (VIH) to select the Device Code byte.
3