AM1
mm General tolerance: 0.4
4. Oil tight types
The pushbutton part is sealed with the rubber cap and the connected part between the cap and body is also coated with resin so that
these parts are kept away from foreign matters. This type has resistance to oil.
Rigid lever
Operating force,
max.
CAD Data
0.69 N
0.14 N
10
Plunger seal
Lever: Stainless steel
4.8
Release force,
min.
26.1
Pretravel,
max. mm
R63.5
Movement differential,
max. mm
1.5
F.P.
20.1 0.5
O.P.
Overtravel,
min. mm
5.6
Operating position,
mm
19.1 0.7
AM1511F (Solder terminal)
AM1711F (Screw terminal)
Rigid short roller lever
CAD Data
Operating force,
max.
1.67 N
0.42 N
4.5
Plunger seal
Roller 9.5 dia.×4:
Release force,
min.
Plastic
26.1
Pretravel, max.
mm
R26.7
Movement differential,
max. mm
F.P.
O.P.
0.7
20.1 0.5
16.9 0.8
Overtravel,
min. mm
2.4
AM1514F (Solder terminal)
AM1714F (Screw terminal)
Operating position,
mm
30.2 0.4
Rigid roller lever
CAD Data
Operating force,
max.
0.98 N
0.20 N
7.5
Roller 9.5 dia.×4:
Plunger seal
Plastic
Release force,
min.
26.1
R48.3
Pretravel,
max. mm
F.P.
Movement differential,
max. mm
O.P.
1.3
20.1 0.5
16.9 0.8
Overtravel,
min. mm
3.6
Operating position,
mm
AM1513F (Solder terminal)
AM1713F (Screw terminal)
30.2 0.7
NOTES
1. Regarding fastening of switch body
1) In fastening the switch body, use M4
mounting screws to attach switches with
the torque 1.5 N·m or less.
impaired. In addition, the force applied by
the operating device should be in a
perpendicular direction. Even if the
pushbutton is used in the full total travel
position, there will be no influence on the
life of the switch.
4. Avoid using switches in the
following conditions:
• In corrosive gases such as hydrogen
sulfide.
2) After mounting and wiring, the
insulation distance between ground and
each terminal should be confirmed as
sufficient.
2. Adjustment of the operating device
The operating device should be
positioned so that it applies no stress to
the pushbutton or actuator when the
switch is in the open position. If this
condition is exceeded, the mechanical
and electrical performance will be
• In flammable or explosive gases such
as gasoline or thinner etc.
• In a dusty environment.
• In an ambient humidity over 85%.
• In conditions where the perpendicular
operating speed is less than 0.1 mm/sec.
or more than 1,000 mm/sec.
• In a silicon atmosphere.
5. Others
3. Soldering operations
Soldering should be done in less than 5
seconds, with a 60 watt iron (tip
temperature = 350°C max.). Care should
be taken not to apply force to the terminal
during soldering.
Caution should be taken not to drop
switches.
AECTB8E 201201-T
Panasonic Corporation Automation Controls Business Unit industrial.panasonic.com/ac/e