5秒后页面跳转
ADP1762ACPZ-1.2-R7 PDF预览

ADP1762ACPZ-1.2-R7

更新时间: 2024-01-24 04:34:28
品牌 Logo 应用领域
亚德诺 - ADI 输出元件调节器
页数 文件大小 规格书
19页 1002K
描述
2 A, Low VIN, Low Noise, CMOS Linear Regulator

ADP1762ACPZ-1.2-R7 技术参数

是否无铅: 含铅是否Rohs认证: 符合
生命周期:Active包装说明:HVQCCN,
针数:16Reach Compliance Code:compliant
风险等级:2.23最大回动电压 1:0.095 V
最大输入电压:1.98 V最小输入电压:1.4 V
JESD-30 代码:S-XQCC-N16JESD-609代码:e3
长度:3 mm湿度敏感等级:3
功能数量:1端子数量:16
工作温度TJ-Max:125 °C工作温度TJ-Min:-40 °C
最大输出电流 1:2 A最大输出电压 1:1.218 V
最小输出电压 1:1.182 V标称输出电压 1:1.2 V
封装主体材料:UNSPECIFIED封装代码:HVQCCN
封装形状:SQUARE封装形式:CHIP CARRIER, HEAT SINK/SLUG, VERY THIN PROFILE
峰值回流温度(摄氏度):260调节器类型:FIXED POSITIVE SINGLE OUTPUT LDO REGULATOR
座面最大高度:0.8 mm表面贴装:YES
技术:CMOS端子面层:Tin (Sn)
端子形式:NO LEAD端子节距:0.5 mm
端子位置:QUAD处于峰值回流温度下的最长时间:30
宽度:3 mmBase Number Matches:1

ADP1762ACPZ-1.2-R7 数据手册

 浏览型号ADP1762ACPZ-1.2-R7的Datasheet PDF文件第2页浏览型号ADP1762ACPZ-1.2-R7的Datasheet PDF文件第3页浏览型号ADP1762ACPZ-1.2-R7的Datasheet PDF文件第4页浏览型号ADP1762ACPZ-1.2-R7的Datasheet PDF文件第5页浏览型号ADP1762ACPZ-1.2-R7的Datasheet PDF文件第6页浏览型号ADP1762ACPZ-1.2-R7的Datasheet PDF文件第7页 
2 A, Low VIN, Low Noise,  
CMOS Linear Regulator  
ADP1762  
Data Sheet  
FEATURES  
TYPICAL APPLICATION CIRCUITS  
2 A maximum output current  
Low input voltage supply range  
ADP1762  
V
= 1.5V  
C
OUT  
V
= 1.7V  
OUT  
IN  
VIN  
VOUT  
SENSE  
EN  
C
10µF  
IN  
10µF  
VIN = 1.10 V to 1.98 V, no external bias supply required  
R
ON  
PULL-UP  
Fixed output voltage range: VOUT_FIXED = 0.9 V to 1.5 V  
Adjustable output voltage range: VOUT_ADJ = 0.5 V to 1.5 V  
Ultralow noise: 2 μV rms, 100 Hz to 100 kHz  
Noise spectral density  
100k  
OFF  
PG  
PG  
SS  
VADJ  
C
SS  
10nF  
VREG  
REFCAP  
C
C
1µF  
REF  
GND  
REG  
4 nV/√Hz at 10 kHz  
1µF  
3 nV/√Hz at 100 kHz  
Figure 1. Fixed Output Operation  
Low dropout voltage: 62 mV typical at 2 A load  
Operating supply current: 4.5 mA typical at no load  
1.5ꢀ fixed output voltage accuracy over line, load, and  
temperature  
Excellent power supply rejection ratio (PSRR) performance  
62 dB typical at 10 kHz at 2 A load  
46 dB typical at 100 kHz at 2 A load  
Excellent load/line transient response  
Soft start to reduce inrush current  
Optimized for small 10 μF ceramic capacitors  
Current-limit and thermal overload protection  
Power-good indicator  
ADP1762  
V
= 1.7V  
R
V
= 1.5V  
IN  
OUT  
VIN  
VOUT  
C
C
OUT  
10µF  
IN  
10µF  
SENSE  
ON  
PULL-UP  
100k  
EN  
OFF  
PG  
PG  
SS  
VADJ  
C
R
VREG  
REFCAP  
SS  
10nF  
ADJ  
10kΩ  
C
C
REF  
REG  
1µF  
GND  
1µF  
Figure 2. Adjustable Output Operation  
Table 1. Related Devices  
Precision enable  
Input  
Voltage  
Maximum Fixed/  
16-lead, 3 mm × 3 mm LFCSP package  
Device  
Current  
Adjustable  
Package  
APPLICATIONS  
ADP1761 1.10 V to  
1.98 V  
ADP1763 1.10 V to  
1.98 V  
ADP1740/ 1.6 V to  
ADP1741 3.6 V  
ADP1752/ 1.6 V to  
ADP1753 3.6 V  
1 A  
Fixed/adjustable 16-lead  
LFCSP  
Regulation to noise sensitive applications such as radio  
frequency (RF) transceivers, analog-to-digital converter  
(ADC) and digital-to-analog converter (DAC) circuits,  
phase-locked loops (PLLs), voltage controlled oscillators  
(VCOs) and clocking integrated circuits  
Field-programmable gate array (FPGA) and digital signal  
processor (DSP) supplies  
Medical and healthcare  
3 A  
Fixed/adjustable 16-lead  
LFCSP  
2 A  
Fixed/adjustable 16-lead  
LFCSP  
0.8 A  
1.2 A  
Fixed/adjustable 16-lead  
LFCSP  
Fixed/adjustable 16-lead  
LFCSP  
ADP1754/ 1.6 V to  
ADP1755 3.6 V  
Industrial and instrumentation  
The ADP1762 is optimized for stable operation with small 10 μF  
ceramic output capacitors. The ADP1762 delivers optimal transient  
performance with minimal board area.  
GENERAL DESCRIPTION  
The ADP1762 is a low noise, low dropout (LDO) linear regulator. It  
is designed to operate from a single input supply with an input  
voltage as low as 1.10 V, without the requirement of an external  
bias supply, to increase efficiency and provide up to 2 A of  
output current.  
The ADP1762 is available in fixed output voltages ranging from  
0.9 V to 1.5 V. The output of the adjustable output model can be  
set from 0.5 V to 1.5 V through an external resistor connected  
between VADJ and ground.  
The low 62 mV typical dropout voltage at a 2 A load allows the  
ADP1762 to operate with a small headroom while maintaining  
regulation and providing better efficiency.  
The ADP1762 has an externally programmable soft start time by  
connecting a capacitor to the SS pin. Short-circuit and thermal  
overload protection circuits prevent damage in adverse conditions.  
The ADP1762 is available in a small 16-lead LFCSP package for the  
smallest footprint solution to meet a variety of applications.  
Rev. A  
Document Feedback  
Information furnished by Analog Devices is believed to be accurate and reliable. However, no  
responsibility is assumed by Analog Devices for its use, nor for any infringements of patents or other  
rights of third parties that may result from its use. Specifications subject to change without notice. No  
license is granted by implication or otherwise under any patent or patent rights of Analog Devices.  
Trademarks and registeredtrademarks arethe property of their respective owners.  
One Technology Way, P.O. Box 9106, Norwood, MA 02062-9106, U.S.A.  
Tel: 781.329.4700  
Technical Support  
©2016 Analog Devices, Inc. All rights reserved.  
www.analog.com  
 
 
 
 

与ADP1762ACPZ-1.2-R7相关器件

型号 品牌 描述 获取价格 数据表
ADP1762ACPZ-1.3-R7 ADI 2 A, Low VIN, Low Noise, CMOS Linear Regulator

获取价格

ADP1762ACPZ-1.5-R7 ADI 2 A, Low VIN, Low Noise, CMOS Linear Regulator

获取价格

ADP1762ACPZ-R7 ADI 2 A, Low VIN, Low Noise, CMOS Linear Regulator

获取价格

ADP1762-ADJ-EVALZ ADI CMOS Linear Regulator

获取价格

ADP1762-EVALZ ADI TABLE OF CONTENTS

获取价格

ADP1763 ADI CMOS Linear Regulator

获取价格