ADM1034
PIN CONFIGURATION AND FUNCTION DESCRIPTIONS
1
2
3
4
5
6
7
8
16
15
14
13
12
11
10
9
DRIVE1
TACH1
DRIVE2
TACH2
GND
SCL
SDA
ADM1034
TOP VIEW
(Not to Scale)
ALERT
LOCATION
D2+
V
D2–
CC
THERM
D1+
FAN_FAULT/REF
D1–
Figure 3. Pin Configuration
Table 3. Pin Function Descriptions
Pin No.
Mnemonic
DRIVE1
TACH1
DRIVE2
TACH2
GND
Description
1
2
3
4
5
6
7
DRIVE1 Pin Drives Fan 1. Open-drain output. Requires a pull-up resistor.
Fan 1 Fan Speed Measurement Input. Connects to the fan’s TACH output to measure the fan speed.
DRIVE2 Pin Drives Fan 2. Open-drain output. Requires a pull-up resistor.
Fan 2 Fan Speed Measurement Input. Connects to the fan’s TACH output to measure the fan speed.
Ground for Analog and Digital Circuitry.
Power. Can be powered by 3.3 V standby power if monitoring in low power states is required.
Can be configured as an overtemperature interrupt output, or as an input (to monitor PROCHOT output of
an INTEL CPU). A timer measures assertion times on the THERM pin (either input or output).
VCC
THERM
8
FAN_FAULT/REF
FAN_FAULT: Open-Drain Output. Asserted low when one or both fans stall. Requires a pull-up resistor to VCC.
REF: Analog Input Reference for the THERM Input.
9
D1−
D1+
D2−
D2+
Cathode Connection for the First Thermal Diode or Diode-Connected Transistor.
Anode Connection for the First Thermal Diode or Diode-Connected Transistor.
Cathode Connection for the Second Thermal Diode or Diode-Connected Transistor.
Anode Connection for the Second Thermal Diode or Diode-Connected Transistor.
8-Level Analog Input. Used to determine the correct SMBus version and the SMBus address (in
fixed-and-discoverable mode) and to set the LLL bits in the UDID (in ARP-capable mode).
Open-Drain Output. SMBusALERT pin. Alerts the system in the case of out-of-limit events, such as over
temperature. Can be configured as sticky SMBus mode or comparator mode.
Serial Bus Bidirectional Data. Connects to the SMBus master’s data line. Requires pull-up resistor if not
provided elsewhere in the system.
Serial SMBus Clock Input. Connects to the SMBus master’s clock line. Requires pull-up resistor if not already
provided in the system.
10
11
12
13
LOCATION
14
15
16
ALERT
SDA
SCL
Rev. 0 | Page 7 of 40