5秒后页面跳转
ACC-F223M500P52 PDF预览

ACC-F223M500P52

更新时间: 2024-04-09 18:55:35
品牌 Logo 应用领域
风华高科 - FH 电容器
页数 文件大小 规格书
8页 427K
描述
轴向引线色环电容器

ACC-F223M500P52 数据手册

 浏览型号ACC-F223M500P52的Datasheet PDF文件第2页浏览型号ACC-F223M500P52的Datasheet PDF文件第3页浏览型号ACC-F223M500P52的Datasheet PDF文件第4页浏览型号ACC-F223M500P52的Datasheet PDF文件第5页浏览型号ACC-F223M500P52的Datasheet PDF文件第6页浏览型号ACC-F223M500P52的Datasheet PDF文件第8页 
LEAD MLCCS  
项目  
技术要求  
测试方法和备注  
Item  
Technical Specification  
Test Method and Remarks  
ΔC/C  
C0G:≤±3%±.3pF  
X7R:≤±12.5%  
Y(F): ≤ ±30%  
电压:1.5 倍额定电压  
时间:1000 小时  
温度:C0G/X7R 125,Y5V 85℃  
充电电流:不应超过 50mA  
DF  
COG: Cr30pF 0.5%  
Cr30pF 1/400+20Cr)  
X7R: 5.0%  
放置条件:室温  
高温负荷  
High  
放置时间: 24 时( C0G ,或 48 时  
X7R/Y5V,  
Y(F): 12.5% (CR 0.1uF)  
15.0%(1uF CR 0.1uF)  
17.5% (CR 1uF)  
Temperature  
Loading Test  
Applied Voltage: 2Rated Voltage  
Duration: 1000h  
Temperature125℃  
IR  
Charge/ Discharge Current: 50mA max. Recovery  
Conditions: Room Temperature Recovery Time:  
24h (C0G), or 48h (X7R/Y5V)  
绝缘电Insulation Resistance:  
500MΩ or 25 Ω.F 取较小Whichever is smaller  
外观无可见损伤  
Appearance no visible damage  
固定电容器本体,沿引线方向逐步施加拉力直至  
10N,然后保10 ±1 秒。  
抗拉强度  
Fix the capacitor body, apply the force gradually to  
each lead in the radial direction of the capacitor  
until reaching 10N, and then keeping the force for  
10 ±1 sec.  
Tensile Strength  
无引线断裂或松动等可见不  
良。  
端头强度  
Terminal  
Strength  
对电容器引出端施加2.5N 的力,使引线弯90  
度,持5 秒,然后使引线回到原始位置,接着反  
方向操作一次为一个循环,共重2 次。  
No abnormality such as cut  
lead or looseness.  
弯折强度  
Each lead wire shall be subjected to a force of  
2.5N and then be bent a angle of 90 degree then  
returned to initial position. This operation is done  
over a period of 5 sec. Then second bend in the  
opposite direction shall be made, repeat 2 times.  
Bending Strength  
*以上所示“标准条件”解释如下:温度:5~35,相对湿度:45~85%,气压:86~106kPa  
* Note on standard condition: " standard condition " referred to herein should be defined as follows:  
5 to 35of temperature, 45 to 75% of relative humidity, and 86 to 106kPa of atmospheric pressure.  
* 若测试结果有争议时,仲裁试验用标准大气条件为:温度:25±1,相对湿度:48%~52%, 气压:86~106kPa  
* When there are questions concerning measurement results:In order to provide correlation data, the test should be  
conducted under a condition of 25 degrees plus/minus 1 centigrade of temperature, 48% through 52% of relative humidity  
and 86 to 106 kPa of atmospheric pressure.  
7

与ACC-F223M500P52相关器件

型号 品牌 描述 获取价格 数据表
ACC-F223Z250P26 FH 轴向引线色环电容器

获取价格

ACC-F223Z250P52 FH 轴向引线色环电容器

获取价格

ACC-F223Z500P26 FH 轴向引线色环电容器

获取价格

ACC-F223Z500P52 FH 轴向引线色环电容器

获取价格

ACC-F224M500P52 FH 轴向引线色环电容器

获取价格

ACC-F224Z500P26 FH 轴向引线色环电容器

获取价格