T0701
GSM-GPRS Receiver
Description
The T0701 is a bipolar integrated RF transceiver for The T0701 enables to build a small-sized GSM trans-
GSM-based cellular systems (900/ 1800/ 1900 MHz) and ceiver by adding a single PLL frequency synthesizer
other wireless communication applications. This (main oscillator), a power amplifier (e.g. TST0911) and
integrated circuit consists of a superheterodyne receiver few external components.
st
st
with a high 1 intermediate frequency (IF) of 378 MHz Triple band operation is possible with a 1 IF of 378 MHz
and an offset PLL transmitter architecture. and using only a single channel raster VCO with a tuning
Receiver functions include: low-noise pre–amplifier, range of approximately 8.54%.
mixer, digitally controlled gain amplifiers, quadrature
demodulator, baseband filters, and baseband amplifiers.
Electrostatic sensitive device.
Transmitter functions include: I/Q modulator, phase
Observe precautions for handling.
comparator, auxiliary VCO including PLL functions and
down-converter. The device is controlled by a 3-wire bus.
FD eOanteudreevsice for all GSM bands (900/ 1800/ 1900 MHz)
D Noise figure 4.5 dB; on-chip auxiliary VCO
D Support of GPRS; EDGE compatible (receive path)
D Supply voltage range 2.7 V to 3.3 V
D Modulation loop transmitter architecture avoids TX
spurious, and exhibits excellent noise performance
D Current consumption (continuous operation)
D No TX duplex filter needed, longer battery life
RX mode: 43 mA, @ Vs = 3 V
D 3-wire bus control for RX/ TX frequencies, gain,
TX mode: 50 mA, @ Vs = 3 V
Power-down mode: < 10 µA
modes, and band selection
D 100 dB of total voltage gain
D 64-Pin Thin Quad Flat Package (TQFP64)
Block Diagram
SAW
378 MHz
13 MHz
TCXO
AFC
0ø
im. rej.
filter
RX – I/Q
90 ø
SYM
BPF
LNA
3–wire bus
control
bias
div.
div.
channel
VCO
loop filter
FRJ
CPA
Main
PLL
AUX
PLL
Baseband
IC
PA
13 MHz
2.2 GHz
VCO
div.
Loop
filter
T0701
TXIN
CPM
RX – I
div.
TX
loop filter
PFD &
charge pump
2
TX VCO
0ø
Σ
90ø
div.
modulation
PLL
RX – Q
Figure 1. Block diagram
Rev. A2, 04-Oct-00
1 (5)
Target Specification