5秒后页面跳转
E910.43 PDF预览

E910.43

更新时间: 2024-02-15 12:31:36
品牌 Logo 应用领域
ELMOS 网络接口电信电路
页数 文件大小 规格书
1页 104K
描述
LIN transceiver

E910.43 技术参数

生命周期:Contact Manufacturer包装说明:,
Reach Compliance Code:unknown风险等级:5.81
Is Samacsys:NBase Number Matches:1

E910.43 数据手册

  
BUS IC  
DC/DC CONVERTER  
MOTOR DRIVER IC  
RIPPLE COUNTER  
DRIVER IC  
I/O IC  
SENSOR IC  
SENSOR INTERFACE IC  
K-Bus transceiver  
LIN- / K-Bus transceiver  
LIN transceiver + VREG  
ÿ LIN transceiver  
LIN transceiver + VREG + WD  
Single wire CAN transceiver  
CAN transceiver  
ÿ LIN transceiver  
E910.43  
FEATURES  
DESCRIPTION  
PINNING  
PACKAGE  
ÿ
ÿ
ÿ
Supply voltage range VS 6V to 18V  
Supply voltage range VDD 4.5V to 5.5V  
LIN 2.0 compatible interface for  
data rates up to 20kBaud  
Output slewrate control to reduce EMI  
Short circuit current limitation  
Over temperature protection  
Bus-line DC voltage range 24V to +30V  
Receiver debounce filter  
Very low active current consumption  
Very low standby current (typ. < 10 µA)  
Wake up output by LIN-Bus transition and EN,  
battery power on  
The IC interfaces between a µC and a Local Interconnect Network  
(LIN) bus-line, mainly in automotive sub bus applications. When  
pin EN is at High level (VDD), a digital input signal at pin TxD  
is transferred to the fully protected low side driver on pin BUS.  
The voltage level on pin BUS is detected by a comparator with a  
threshold of nominally 50% of the battery supply VS. After pass-  
ing a debounce filter it is valid on pin RxD as a digital signal refer-  
enced to the digital supply voltage VDD.  
Pin  
1
2
3
4
5
6
7
Name  
RxD  
EN  
VDD  
TxD  
GND  
BUS  
VS  
Description  
Serial data from IC to µC  
Enable activates transmitter,receive and output INH  
+5V digital supply  
Serial data from µC to IC  
Ground  
RxD  
1
2
3
4
8
7
6
5
INH  
VS  
BUS  
GND  
EN  
VDD  
TxD  
ÿ
ÿ
ÿ
ÿ
ÿ
ÿ
ÿ
ÿ
LIN-Bus pin  
+12V positive supply  
Switched battery supply output to activate,  
8
INH  
e.g. an external voltage regulator  
EN also statically keeps the high side output INH active. A high to  
low transition on EN as well as VDD falling under the POR thresh-  
old will dynamically reset INH to high impedance. A debounced  
low level on the bus-line for a certain time will set INH to high  
level as well as a - power on condition - on the battery supply  
pin VS.  
ÿ
ÿ
40°C to +125°C operating temperature  
SO 8n package  
APPLICATION  
Bus interface for Local Interconnect Network (LIN)  
ÿ
communication especially in automobile  
applications  
BLOCK DIAGRAM  
VDD  
ext. voltage  
regulator  
VDD  
VDD  
EN  
INH  
VS  
EN  
wake up  
&
POR  
VBAT  
µC  
BUS  
RXD  
control  
TXD  
slewrate  
control  
Note ELMOS Semiconductor AG (below ELMOS) reserves the right to make changes to the product contained in this publication without notice. ELMOS assumes no responsibility for the use of any  
circuits described herein, conveys no licence under any patent or other right, and makes no representation that the circuits are free of patent infringement. While the information in this publication  
has been checked, no responsibility, however, is assumed for inaccuracies. ELMOS does not recommend the use of any of its products in life support applications where the failure or malfunction of  
the product can reasonably be expected to cause failure of a life-support system or to significantly affect its safety or effectiveness. Products are not authorized for use in such applications.  
Copyright © 2005 ELMOS Reproduction, in part or whole, without the prior written consent of ELMOS, is prohibited.  
14  
www.elmos.de | sales@elmos.de  
elmos product catalog june 2005  
15  

与E910.43相关器件

型号 品牌 描述 获取价格 数据表
E910.44 ELMOS Hall sensor IC

获取价格

E910.45 ELMOS LIN transceiver with voltage regulator

获取价格

E910.46 ELMOS EC motor control

获取价格

E910.47 ELMOS Non volatile contact monitor

获取价格

E910.48 ELMOS LIN transceiver with voltage regulator and watchdog

获取价格

E910.52 ELMOS Contact monitor to GND or VBAT (16 channel, serial interface)

获取价格