ADVANCE INFORMATION
8x930Hx
UNIVERSAL SERIAL BUS HUB
PERIPHERAL CONTROLLER
■ USB Hub with One Upstream, One
■ Embedded Function FIFO Data Buffers
Internal Downstream, and Three
External Downstream Ports on HD/HE
Parts or Four on HF/HG Parts
— Three Pairs of 16-byte Transmit and
Receive FIFOs
— One Pair of Configurable Transmit
and Receive FIFOs (1 Kbyte total)
— Complete Universal Serial Bus Speci-
fication 1.0 Compatibility
■ Automatic Transmit/Receive FIFO
— Serves as both USB Hub and USB
Embedded Function (Internal Port)
Management
■ Three USB Interrupt Vectors
— Endpoint Transmit/Receive Done
— Start of Frame/Hub Endpoint Done
— Global Suspend/Resume
■ USB Hub
— Connectivity Management
— Downstream Device
Connect/Disconnect Detection
— Power Management, Including
Suspend and Resume
■ Low Clock Mode
■ User-selectable Configurations
— External Wait State
— External Address Range
— Page Mode
— Bus Fault Detection and Recovery
— Full and Low Speed Downstream
Device Support
■ Output Pin for Port Power Switching
■ Input Pin for Overcurrent Detection
■ USB Embedded Function
■ Real-time Wait Function
■ 256-Kbyte External Code/Data Memory
Space
— Supports Isochronous and
Non-isochronous Data
■ On-chip ROM Options
— 0, 8, or 16 Kbytes
■ On-chip USB Transceivers
■ 1024 bytes On-chip Data RAM
■ Four Input/Output Ports
■ Standard MCS® 51 UART
■ Serial Bus Interface Engine (SIE)
— Packet Decoding/Generation
— CRC Generation and Checking
■ Power-saving Idle and Powerdown
— NRZI Encoding/Decoding and
Bit-stuffing
Modes
■ Register-based MCS® 251 Architecture
■ Hub FIFO Data Buffers
■ Code-compatible with MCS 51 and
— One Pair of 16-byte Transmit and
Receive FIFOs
MCS 251 Microcontrollers
■ 12-MHz Crystal Operation
— One 1-byte Transmit Register
The 8x930Hx USB hub peripheral controller is based on the MCS 251 microcontroller. It consists of standard
8XC251Sx peripherals plus a USB module. The USB module provides both USB hub and USB embedded
function capabilities. The 8x930Hx supports USB hub functionality, embedded function, suspend/resume
modes, isochronous/non-isochronous transfers, and it is fully USB rev 1.0 specification compliant. The USB
module contains one internal and three (or four) external downstream ports and integrates the USB trans-
ceivers, serial bus interface engine (SIE), hub interface unit (HIU), function interface unit (FIU), and
transmit/receive FIFOs. The 8x930Hx uses the standard instruction set of the MCS 251 architecture, which is
binary code compatible with the MCS 51 architecture.
COPYRIGHT © INTEL CORPORATION, 1997
May 1997
Order Number: 272928-003