5秒后页面跳转
7B14-04-1 PDF预览

7B14-04-1

更新时间: 2024-02-19 12:03:39
品牌 Logo 应用领域
亚德诺 - ADI 模拟IC信号电路
页数 文件大小 规格书
8页 530K
描述
Non Isolated, Linearized RTD Input

7B14-04-1 技术参数

Source Url Status Check Date:2013-05-01 14:56:07.246是否无铅: 含铅
是否Rohs认证: 不符合生命周期:Obsolete
Reach Compliance Code:compliantHTS代码:8542.39.00.01
风险等级:5.62Is Samacsys:N
模拟集成电路 - 其他类型:ANALOG CIRCUITJESD-30 代码:R-XDMA-P6
端子数量:6封装主体材料:UNSPECIFIED
封装形状:RECTANGULAR封装形式:MICROELECTRONIC ASSEMBLY
峰值回流温度(摄氏度):NOT SPECIFIED认证状态:Not Qualified
标称供电电压 (Vsup):24 V表面贴装:NO
端子形式:PIN/PEG端子位置:DUAL
处于峰值回流温度下的最长时间:NOT SPECIFIEDBase Number Matches:1

7B14-04-1 数据手册

 浏览型号7B14-04-1的Datasheet PDF文件第1页浏览型号7B14-04-1的Datasheet PDF文件第3页浏览型号7B14-04-1的Datasheet PDF文件第4页浏览型号7B14-04-1的Datasheet PDF文件第5页浏览型号7B14-04-1的Datasheet PDF文件第6页浏览型号7B14-04-1的Datasheet PDF文件第7页 
7B14  
GENERAL DESCRIPTION  
Hz filter preconditions the RTD signal prior to amplification,  
The 7B14 is a low cost, single-channel signal conditioning  
module that interfaces, amplifies and filters input voltages from  
a wide variety of two-and three-wire platinum, copper and  
nickel Resistor Temperature Detectors (RTDs) and provides a  
precision output of either +1 V to +5 V or 0 V to +10 V, linear  
with temperature. Model 7B14 features a nonlinearity of +0.05%  
maximum (Pt and Cu RTDs). RTD excitation current, three-  
wire lead resistance compensation and a predictable upscale  
open circuit indication provide a complete signal conditioning  
solution. Rated to operate with a nominal +24 VDC supply,  
Model 7B14 is mix-and-match and hot-swappable with other  
7B Series input modules, so it can be inserted or removed from  
any socket in the same backplane without disturbing system  
power.  
provided by a low drift input amplifier. The output section  
contains a two-pole low pass filter (-3 dB @ 3 Hz) and a buffer  
amplifier. The two-pole output filter and subsequent buffer  
ensure that a low noise, low impedance (<1) signal is available  
at the output to drive loads to 2 kminimum.  
.
The three input pins of Model 7B14 are fully protected up to  
+30 VDC. A 250 uA excitation current for platinum and nickel  
RTDs and a 1mA excitation current for copper RTDs is  
provided to create an input voltage to the 7B14. This current  
also provides the upscale open circuit indication. A one-pole 3  
Figure 2  
Rev. 0 | Page 2 of 8  

与7B14-04-1相关器件

型号 品牌 描述 获取价格 数据表
7B14-04-2 ADI Non Isolated, Linearized RTD Input

获取价格

7B14-05-1 ADI Non Isolated, Linearized RTD Input

获取价格

7B14-05-2 ADI Non Isolated, Linearized RTD Input

获取价格

7B14-C-02-1 ADI Non Isolated, Linearized RTD Input

获取价格

7B14-C-02-2 ADI Non Isolated, Linearized RTD Input

获取价格

7B14-N-01-1 ADI Non Isolated, Linearized RTD Input

获取价格