2111 Comprehensive Drive
Aurora, Illinois 60505
Phone: 630-851-4722
Fax: 630- 851- 5040
www.conwin.com
Package Characteristics
Hermetically sealed ceramic package and metal cover
Suggested Pad Layout
Package
Environmental Characteristics
Temperature Cycle
The specimen shall meet electrical characteristics after
tested 5 cycles of -55°C / 30 minutes and +125°C / 30 minutes
Hermetical
No bubbles appear in Flourinert (FC-43) at 125°C 5°C for 5 minutes
Solvent Resistance
Marking will withstand immersion in
Isopropyl Alcohol or Trichloroethylene
Bypass capacitor, C-by, should
be ceramic capacitor ≥ ±.1uf±
Soldering
General Conditions
260°C max x 10 sec max x 2 times max or
230°C max x 180 sec max x 1 time
Typical Operation Data
(Vapor phase reflow)
20 to 100 sec up to 215°C, 50 sec
Test Circuit
at 215°C, then down to room temperature per 1 to 5°C / sec
OSCILLOSCOPE
Mechanical Characteristics
PROBE
POWER
SUPPLY
Free Drop
Vibration
The specimen shall meet electrical characteristics after tested 3 times,
Free Drop testing on the hard wooden board from a height of 75 cm.
OSC
The specimen shall meet electrical characteristics after tested
by the following conditions: 10-55Hz 1.5mm Amplitude,
55-2000 Hz 20 G's, 2 hours for each plane
After applied Thermal Shock of 260°C
max x 10 sec max x 2 times, or 230°C max x 180 sec max,
the specimen shall meet electrical characteristics
FREQ
INPUT FOR E/D
COUNTER
Thermal Shock
Solderability
(EIAJ-RCX-0102.101 Condition 1a)
1) Flux: MIL-F-14256 (WW Rosin=25%, Isopropyl Alcohol = 75%)
2) Solder: QQ-S-571 (Sn = 63%, Pb = 37%)
OutputWaveform
3) Solder bath temperature: 235°C 5°C
4) Depth of immersion: Up to electrical terminal
5) Immersing time: Within 2 sec 0.5 sec into solder bath
After performing the above procedures, a newly soldered coverage shall be greater than 90%
Pad Connection
1: Enable / Disable
2: Ground
SYMMETRY
3: Output
4: Vcc
Dimensional Tolerance: ± ±.0ꢂ ꢀ±ꢁ.8mmꢃ
± ±..ꢁꢂ ꢀ±10ꢄmmꢃ
Tape and Reel Dimensions
Ordering Information
ꢄ11ꢁ
- 0.±.. MHz
CLOCK
SERIES
CENTER
FREQUENCY
Dimensional Tolerance: ±.ꢀ0± 2" (.508mm)
Dimensional Tolerance: ± ±.02
± ±..ꢁ2 ꢀ±
±.005"(.127mm)
Bulletin
Page
Sm088
2 of 2
Revision
Date
01
Meets EIA-481A and EIAJ-1..9B
0,... PCS/REEL
20 June 2002
Specifications subject to change without notice. All dimensions in inches. © Copyright 1998 The Connor-Winfield Corporation