5秒后页面跳转
5962R9316102KXC PDF预览

5962R9316102KXC

更新时间: 2024-09-28 14:46:47
品牌 Logo 应用领域
CRANE 局域网
页数 文件大小 规格书
14页 1168K
描述
Analog Circuit, Hybrid,

5962R9316102KXC 数据手册

 浏览型号5962R9316102KXC的Datasheet PDF文件第2页浏览型号5962R9316102KXC的Datasheet PDF文件第3页浏览型号5962R9316102KXC的Datasheet PDF文件第4页浏览型号5962R9316102KXC的Datasheet PDF文件第5页浏览型号5962R9316102KXC的Datasheet PDF文件第6页浏览型号5962R9316102KXC的Datasheet PDF文件第7页 
Crane Aerospace & Electronics Power Solutions  
SMFL Single and Dual DC/DC Converters  
28 Voꢋt input – 65 Watt  
Features  
pꢀꢁꢀllꢂl ꢃꢄꢂꢁꢀꢅꢆꢃꢇ wꢆꢅh ꢈꢉꢁꢁꢂꢇꢅ ꢊhꢀꢁꢂ, ꢉꢄ ꢅꢃ 3 ꢉꢇꢆꢅꢊ (ꢉꢄ  
ꢅꢃ 185 wꢀꢅꢅꢊ)  
•ꢀ Operating temperature -55° to +125°C  
•ꢀ Qualified to MIL-PRF-38534 Class H and K  
•ꢀ Radiation hardness assurance (RHA) to level R 100 kRad(Si)  
•ꢀ Input voltage range 16 to 40 VDC  
•ꢀ Transient protection 80 V for 50 ms  
•ꢀ Fully isolated, magnetic feedback  
•ꢀ Fixed high frequency switching  
MODELS  
VDc OutPut  
•ꢀ Remote sense and output trim on single output models  
•ꢀ Inhibit function  
SINꢀLE  
3.3  
5
DꢁAL  
±5  
±12  
±15  
•ꢀ Synchronization input and output  
•ꢀ Indefinite short circuit protection  
12  
15  
•ꢀ High power density with up to 85% efficiency  
description  
mode feedback loop improves transient response in a manner  
similar to primary current mode control and allows for ease of  
paralleling, but without the cost and complexity.  
The Interpoint™ SMFL Series™ 28-volt DC/DC converters  
are rated up to 65 watts output power over a -55° to +125°C  
temperature range with a 28 VDC nominal input. On dual output  
models up to 70% of the rated output power can be drawn from  
either the positive or negative outputs. Current sharing allows  
the units to be paralleled for total power of up to 185 watts. The  
welded, hermetically sealed package is only 3.0 x 1.5 x 0.40  
inches, giving the series an overall power density of up to 43  
watts per cubic inch.  
The constant frequency, pulse-width modulated converters use  
a quasi-square wave single-ended forward design. Tight load  
regulation is achieved through a wide-bandwidth magnetic feed-  
back circuit. The output voltage on single SMFL models can  
be trimmed to a specific output voltage by adding an external  
resistor (see Figure 1 for resistor values).  
Screening  
inhibit  
SMFL converters, also available on SMD drawings, offer the  
following screening options: Space Prototype (O), Class H, or  
Class K. Radiation tolerant to Radiation Hardness Assurance  
(RHA) levels of “-” (O), “P,” or “R,” per MIL-PRF-38534. Interpoint  
model numbers use an “O” in the RHA designator position to  
indicate the “-” (dash) Radiation Hardness Assurance level of  
MIL-PRF-38534, which is defined as “no RHA”. See Screening  
Tables 1 and 2  
The SMFL Series converters have two inhibit terminals (INH1  
and INH2) that can be used to disable power conversion,  
resulting in a very low quiescent input current and no generation  
of switching noise. An active low (<0.8 volts) is required to inhibit  
the converter between INH1 (pin 4) and Input Common (pin  
2). An active low (<0.5 volts) is required to inhibit the converter  
between INH2 (pin 12) and Output Common (pin 8).  
Sync  
DeSign FeatureS  
SMFL Series converters are switching regulators that use a  
quasi-square wave, single ended forward converter design with a  
constant switching frequency of 600 kHz typical.  
Converters may be synced to an external clock (525 to 675 kHz)  
or to one another by using the sync in or out pins. The nominal  
free-run switching frequency is 600 kHz.  
Isolation between input and output circuits is provided with a  
transformer in the forward path and a wide bandwidth magnetic  
coupling in the feedback control loop. The SMFL uses a unique  
dual loop feedback technique that controls output current with  
an inner feedback loop and an output voltage with a cascaded  
voltage mode feedback loop. The additional secondary current  
current Share anD Parallel OPeratiOn  
Multiple SMFL converters may be used in parallel to drive a  
common load (see Figure 2). Only single output models with  
SENSE and SNS RTN can be used in the share mode. In this  
mode of operation the load current is shared by two or three  
Crane Aerospace & Electronics  
Page 1 of 14  
SMFL Rev AA - 2012.03.19  
The information in this document is a derivative of documents cleared  
by the Department of Defense (DoD) Office of Security Review (OSR) for public release.  
OSR case numbers 09-S-0996 dated March 13, 2009 and 09-S-1960 dated June 22, 2009.  
Power Solutions – Interpoint Products  
10301 Willows Rd. NE, Redmond, WA 98052  
+1.425.882.3100 • power@crane-eg.com  
www.craneae.com/interpoint  

与5962R9316102KXC相关器件

型号 品牌 获取价格 描述 数据表
5962R9316302HTA ETC

获取价格

DC to DC Converter
5962R9316302HTC ETC

获取价格

DC to DC Converter
5962R9316302HUA ETC

获取价格

DC to DC Converter
5962R9316302HUC ETC

获取价格

DC to DC Converter
5962R9316302HXA ETC

获取价格

DC to DC Converter
5962R9316302HXC ETC

获取价格

DC to DC Converter
5962R9316302HYA ETC

获取价格

DC to DC Converter
5962R9316302HYC ETC

获取价格

DC to DC Converter
5962R9316302HZA ETC

获取价格

DC to DC Converter
5962R9316302HZC ETC

获取价格

DC to DC Converter