1.2.4 Case outlines. The case outlines are as designated in MIL-STD-1835 and as follows:
Outline letter
Descriptive designator
Terminals
Package style
X
Z
See figure 1
See figure 1
8
8
Dual in-line package
Flange
1.2.5 Lead finish. The lead finish shall be as specified in MIL-PRF-38534.
1.3 Absolute maximum ratings. 1/
Input voltage range...................................................................................
Power dissipation (PD)..............................................................................
Lead temperature (soldering, 10 seconds)...............................................
Storage temperature range.......................................................................
-0.5 V dc to +50 V dc
8 W
+300C
-65C to +135C
1.4 Recommended operating conditions.
Input voltage range...................................................................................
Output currents:
+16 V dc to +40 V dc
+5 V output............................................................................................
15 V output..........................................................................................
Output power 2/ 3/ ...................................................................................
Case operating temperature range (TC) ...................................................
1200 mA
66.7 mA
8 W
-55C to +125C
2. APPLICABLE DOCUMENTS
2.1 Government specification, standards, and handbooks. The following specification, standards, and handbooks form a
part of this drawing to the extent specified herein. Unless otherwise specified, the issues of these documents are those cited in
the solicitation or contract.
DEPARTMENT OF DEFENSE SPECIFICATION
MIL-PRF-38534 - Hybrid Microcircuits, General Specification for.
DEPARTMENT OF DEFENSE STANDARDS
MIL-STD-883 - Test Method Standard Microcircuits.
MIL-STD-1835 - Interface Standard for Electronic Component Case Outlines.
DEPARTMENT OF DEFENSE HANDBOOKS
MIL-HDBK-103 - List of Standard Microcircuit Drawings.
MIL-HDBK-780 - Standard Microcircuit Drawings.
(Copies of these documents are available online at https://assist.daps.dla.mil/quicksearch/ or from the Standardization
Document Order Desk, 700 Robbins Avenue, Building 4D, Philadelphia, PA 19111-5094.)
2.2 Order of precedence. In the event of a conflict between the text of this drawing and the references cited herein, the text
of this drawing takes precedence. Nothing in this document, however, supersedes applicable laws and regulations unless a
specific exemption has been obtained.
1/ Stresses above the absolute maximum rating may cause permanent damage to the device. Extended operation at the
maximum levels may degrade performance and affect reliability.
2/ Derate output power linearly above case temperature +125C to 0 at +135C.
3/ At least 20 percent of the total power should be from the main (+5 volt) output.
SIZE
STANDARD
5962-94623
A
MICROCIRCUIT DRAWING
REVISION LEVEL
SHEET
DLA LAND AND MARITIME
COLUMBUS, OHIO 43218-3990
C
3
DSCC FORM 2234
APR 97