1.3 Absolute maximum ratings. 1/
Supply voltage (V ) ....................................................................... ±20 V
S
Differential input current ................................................................ ±10 mA 2/
Input voltage (V ) ......................................................................... ±20 V
IN
Power dissipation (P ) .................................................................. 24 mW
D
Output short circuit duration ........................................................... Indefinite
Storage temperature range ............................................................ -65°C to +150°C
Lead temperature (soldering, 10 seconds) .................................... +300°C
Thermal resistance, junction-to-case (θ ) .................................... See MIL-STD-1835
JC
Thermal resistance, junction-to-ambient (θ ):
JA
Case G ....................................................................................... +150°C/W
Case P ....................................................................................... +100°C/W
1.4 Recommended operating conditions.
Supply voltage (V ) ....................................................................... ±15 V
S
Ambient operating temperature range (T ) ................................... -55°C to +125°C
A
2. APPLICABLE DOCUMENTS
2.1 Government specification, standards, and handbooks. The following specification, standards, and handbooks form a part
of this drawing to the extent specified herein. Unless otherwise specified, the issues of these documents are those cited in the
solicitation or contract.
DEPARTMENT OF DEFENSE SPECIFICATION
MIL-PRF-38535 - Integrated Circuits, Manufacturing, General Specification for.
DEPARTMENT OF DEFENSE STANDARDS
MIL-STD-883
-
Test Method Standard Microcircuits.
MIL-STD-1835 - Interface Standard Electronic Component Case Outlines.
DEPARTMENT OF DEFENSE HANDBOOKS
MIL-HDBK-103 - List of Standard Microcircuit Drawings.
MIL-HDBK-780 - Standard Microcircuit Drawings.
(Copies of these documents are available online at http://assist.daps.dla.mil/quicksearch/ or from the Standardization
Document Order Desk, 700 Robbins Avenue, Building 4D, Philadelphia, PA 19111-5094.)
2.2 Order of precedence. In the event of a conflict between the text of this drawing and the references cited herein, the text
of this drawing takes precedence. Nothing in this document, however, supersedes applicable laws and regulations unless a
specific exemption has been obtained.
1/ Stresses above the absolute maximum rating may cause permanent damage to the device. Extended operation at the
maximum levels may degrade performance and affect reliability.
2/ Differential input voltages greater than 1 V will cause excessive current to flow through the input protection diodes unless
limiting resistance is used.
SIZE
STANDARD
MICROCIRCUIT DRAWING
5962-90842
A
DEFENSE SUPPLY CENTER COLUMBUS
COLUMBUS, OHIO 43218-3990
REVISION LEVEL
C
SHEET
3
DSCC FORM 2234
APR 97