408-4064
Refer to the table in Figure 1 and select wire of the
specified size and insulation diameter. Strip the wire to
the length indicated in Figure 1, taking care not to nick
or cut wire strands. Select an applicable contact and
identify the appropriate die assembly according to the
wire size markings on the die. Refer to Figure 3 and
proceed as follows:
4. Insert stripped wire into contact insulation and
wire barrels until it is butted against the wire stop
on the contact, as shown in Figure 3.
5. Holding the wire in place, squeeze tool handles
together until ratchet releases. Allow tool handles
to open and remove crimped contact.
6. Check the contact's crimp height as described
in Section 6, Crimp Height Inspection. If
necessary, adjust the crimp height as described
in Section 7, CRIMP HEIGHT ADJUSTMENT.
1. Hold the tool so that the back (wire side) is
facing you. Squeeze tool handles together and
allow them to open fully.
2. Holding the contact by the insulation barrel,
insert the contact—mating end first—into the
locator slot. Position the contact so that the open
“U” of the wire and insulation barrels face the top
of the tool. Make sure the contact butts against
the adjustment screw. Check that the contact is
centered with the die assembly wire and
5. CONTACT SUPPORT ADJUSTMENT (Figure 3)
1. .Make a sample crimp according to Section 4,
CRIMPING PROCEDURE. If the crimp is out of
alignment, adjustment is required.
2. To move the contact from side-to-side, loosen
the nut that holds the locator to the frame and
slide the locator until the contact is properly
positioned. Hold the locator in place and tighten
the nut.
insulation anvils. If adjustment is required, refer to
Section 5, CONTACT SUPPORT ADJUSTMENT.
Make sure that both sides of the insulation barrel
are started evenly into the crimping section. Do not
NOTE
attempt to crimp an improperly positioned contact.
3. To move the contact in or out, loosen the nut
on the adjustment screw and turn the screw until
the contact is properly positioned. Hold the screw
in place and tighten the nut.
i
3. Hold the contact in position and squeeze the
tool handles together until ratchet engages
sufficiently to hold the contact in position. Do
NOT deform insulation barrel or wire barrel.
4. If the crimp is still out of alignment, repeat the
adjustment procedure.CRIMP HEIGHT
INSPECTION.
The ratchet has detents that create audible clicks
as the tool handles are closed.
NOTE
i
Adjustment
Screw
Back of Tool
(Wire Side)
“A”
Strip
Length
Locator
Wire Inserted
in Contact
Wire Inserted to
Contact Wire Stop
TOOL
DIMENSION A
58517-1, 58517-2,
58517-3, 58517-4
58517-5
2.641 [.104]
Locator Slot
Wire
4.191 [.165]
Figure 3
3 of 5
Rev F
5秒后页面跳转
STM32F030C6芯片介绍：主要参数分析、引脚配置说明、功耗及封装
PCF8591数据手册解读：参数、引脚说明
一文带你了解ss8050参数、引脚配置、应用指南
深入解析AD7606高性能多通道模数转换器：资料手册参数分析
微信公众号
抖音公众号
浙公网安备 33010502006866号 浙ICP备10014259号-119
营业执照ICP证
数据手册
如果您发现信息不准确，
