Surface Mount Fuse Datasheet
422A Series
AEC-Q200 Qualified > Ceramic Fuse
Temperature Re-rating Curve
AverageTime Current Curves
100
140%
120%
100%
80%
60%
40%
20%
0%
10
-60 -50 -40 -30 -20 -10
0
10 20 30 40 50 60 70 80 90 100 110 120 130
1
Temperature (degC)
Notes
1. Re-rating depicted in this curve is in addition to the standard re-rating of 25% for continuous
0.1
operation.
Example:
For continuous operation at 85ºC, the fuse should be rerated as follows:
I = (0.75)(0.90)IN = (0.675)IN
0.01
Pulse CycleWithstand Capability
No. of Pulses to withstand
Ratio of Pulse I2t to Nominal I2t
100,000
10,000
1,000
100
Pulse I2t = 18% of Nominal Melting I2t
Pulse I2t = 29% of Nominal Melting I2t
Pulse I2t = 38% of Nominal Melting I2t
Pulse I2t = 48% of Nominal Melting I2t
0.001
1
10
100
Current in Amperes
Note
* Being tested
Soldering Perameters
Pb – Free
assembly
150 °C
Reflow Condition
-Temperature Min (Ts(min)
-Temperature Max (Ts(max)
-Time (Min to Max) (ts)
)
tP
TP
Critical Zone
TL to TP
Pre Heat
)
200 °C
Ramp-up
60–180 secs
5 °C/second max.
5 °C/second max.
217 °C
TL
TS(max)
tL
Average ramp up rate (LiquidusTemp (TL) to peak
TS(max) toTL - Ramp-up Rate
Ramp-down
Preheat
-Temperature (TL) (Liquidus)
Reflow
TS(min)
-Temperature (tL)
60–150 secs
260+0/–5 °C
10–30 seconds
6°C/second max.
8 minutes max.
260 °C
tS
PeakTemperature (TP)
25
Time within 5 °C of actual peakTemperature (tp)
Ramp-down Rate
time to peak temperature
Time
Time 25 °C to peakTemperature (TP)
Do not exceed
260°C PeakTemperature,
10 seconds max.
Wave Soldering Parameters
© 2023 Littelfuse, Inc.
Specifications are subject to change without notice.
2
Revised: GD. 05/24/23