5秒后页面跳转
2100TS PDF预览

2100TS

更新时间: 2024-09-30 06:25:23
品牌 Logo 应用领域
SYSTEMSENSOR /
页数 文件大小 规格书
4页 77K
描述
Smoke Detectors

2100TS 数据手册

 浏览型号2100TS的Datasheet PDF文件第2页浏览型号2100TS的Datasheet PDF文件第3页浏览型号2100TS的Datasheet PDF文件第4页 
INSTALLATION AND MAINTENANCE INSTRUCTIONS  
2100S and 2100TS Photoelectronic  
Smoke Detectors  
3825 Ohio Avenue, St. Charles, Illinois 60174  
1-800-SENSOR2, FAX: 630-377-6495  
Specifications  
Diameter:  
5.5 inches (140 mm)  
Height (including mounting bracket):  
Weight:  
1.9 inches (48 mm)  
5.3 oz. (150 g)  
Operating Temperature Range:  
Model 2100S: 32° to 120°F (0° to 50°C)  
Model 2100TS: 32° to 100°F (0° to 38°C)  
Operating Humidity Range:  
Latching Alarm:  
10% to 93% Relative Humidity, Noncondensing  
Reset by momentary power interruption  
Heat Sensor (Model 2100TS only):  
Electrical Ratings  
135°F Fixed Temperature Electronic Thermistor  
System Voltage –  
Nominal:  
Minimum:  
Maximum:  
12 or 24 VDC  
8.5 VDC  
35 VDC  
Maximum Ripple Voltage:  
Start-up Capacitance:  
Standby Current:  
30% of nom. Voltage (peak to peak)  
0.02 µF maximum  
50 µA maximum  
Alarm Ratings:  
4.2 VDC minimum at 10 mA.  
6.6 VDC maximum at 130 mA.  
(Alarm current must be limited to 130 mA maximum by the control panel. If  
used, the RA400Z Remote Annunciator operates within the specified detector  
alarm currents.)  
Reset Voltage:  
Reset Time:  
2.5 VDC minimum  
0.3 seconds maximum  
Start-up Time:  
30 seconds maximum (after 60 second reset)  
Before Installing  
Please thoroughly read System Sensor manual I56-407,  
Guide for Proper Use of System Smoke Detectors, which pro-  
vides detailed information on detector spacing, placement,  
zoning, wiring, and special applications. Copies of this  
manual are available at no charge from System Sensor.  
Installation of these detectors is simplified by the use of a  
mounting bracket and a plug-in screw terminal block that  
can be prewired to the system, allowing the detector to be  
easily installed or removed. The detector’s sensitivity can  
be tested in place using the MOD400R Test Module.  
NOTICE: This manual shall be left with the owner/user of  
this equipment.  
An LED on the detector provides a local visual indication of  
the detector’s status. If power is applied to the detector, and  
it is functioning normally in standby mode within the listed  
sensitivity ranges, the status LED blinks once every ten sec-  
onds. The LED also provides a visual indication that main-  
tenance is required. If the LED stops blinking, the detector  
is either not powered, out of the listed sensitivity range,  
and/or unable to function properly. The test switch will not  
operate if the detector is below the insensitive limit. The  
LED will also latch on when the detector is in alarm.  
IMPORTANT: This detector must be tested and maintained  
regularly following NFPA 72 requirements. The detector  
should be cleaned at least once a year.  
General Description  
Model 2100S is a 2-wire photoelectronic smoke detector  
that uses a state-of-the-art optical sensing chamber. This  
detector is designed to provide open area protection and to  
be used with compatible UL-listed panels only. Model  
2100TS features a restorable, built-in, fixed-temperature  
(135°F) thermal detector.  
D200-54-00  
1
I56-710-14R  

与2100TS相关器件

型号 品牌 获取价格 描述 数据表
2101 FRONTIER

获取价格

Insert Molded Coil
210-1000-FT10W RCD

获取价格

Fixed Resistor, Wire Wound, 2W, 100ohm, 40V, 1% +/-Tol, 10ppm/Cel,
210-1002-FB10Q RCD

获取价格

Fixed Resistor, Wire Wound, 2W, 10000ohm, 40V, 1% +/-Tol, 10ppm/Cel,
210-1002-FB10W RCD

获取价格

Fixed Resistor, Wire Wound, 2W, 10000ohm, 40V, 1% +/-Tol, 10ppm/Cel,
210-1002-FBQ RCD

获取价格

Fixed Resistor, Wire Wound, 2W, 10000ohm, 40V, 1% +/-Tol, 20ppm/Cel,
210-100-HB5 RCD

获取价格

Fixed Resistor, Wire Wound, 2W, 10ohm, 40V, 3% +/-Tol, 5ppm/Cel,
210-100-HT5 RCD

获取价格

Fixed Resistor, Wire Wound, 2W, 10ohm, 40V, 3% +/-Tol, 5ppm/Cel,
210-100-JB10 RCD

获取价格

Fixed Resistor, Wire Wound, 2W, 10ohm, 40V, 5% +/-Tol, 10ppm/Cel,
210-100-JB5Q RCD

获取价格

Fixed Resistor, Wire Wound, 2W, 10ohm, 40V, 5% +/-Tol, 5ppm/Cel,
210-100-JB5W RCD

获取价格

Fixed Resistor, Wire Wound, 2W, 10ohm, 40V, 5% +/-Tol, 5ppm/Cel,