1339 Datasheet
Pin Assignment (8-TSSOP/8-SOIC)
Pin Assignment (16-SOIC)
X1
8
7
6
5
16
15
14
13
1
2
3
4
VCC
1
2
3
4
5
6
7
8
SCL
SQW/INT
VCC
SDA
X2
SQW/INT
SCL
GND
1339
VBACKUP
VBACKUP
GND
SDA
NC
NC
NC
NC
NC
NC
1339C
NC
NC
NC
12
11
10
9
NC
Pin Descriptions
Pin
Number
Pin
Name
Pin Description/Function
TSSOP SOIC
1
2
—
—
X1
X2
Connections for standard 32.768kHz quartz crystal. The internal oscillator circuitry is
designed for operation with a crystal having a specified load capacitance (CL) of 7pF. An
external 32.768kHz oscillator can also drive the 1339. In this configuration, the X1 pin is
connected to the external oscillator signal and the X2 pin is left floating.
3
14
VBACKUP Backup supply input. Supply voltage must be held between 1.3V and 3.7V for proper
operation. This pin can be connected to a primary cell, such as a lithium button cell.
Additionally, this pin can be connected to a rechargeable cell or a super cap that can be
charged using the trickle charger circuit. Diodes placed in series between the backup
source and the VBAT pin may prevent proper operation. If a backup supply is not required,
VBAT must be connected to ground. UL recognized to ensure against reverse charged
current when used with a lithium cell.
4
5
15
16
GND
SDA
Connect to ground. DC power is provided to the device on these pins.
Serial data input/output. SDA is the input/output pin for the I2C serial interface. The SDA
pin is an open-drain output and requires an external pull-up resistor (2k typical).
6
7
1
2
SCL
Serial clock input. SCL is used to synchronize data movement on the serial interface. It is
an open-drain output and requires an external pull-up resistor (2k typical).
SQW/INT Square-Wave/Interrupt output. Programmable square-wave or interrupt output signal. The
SQW/INT pin is an open-drain output and requires an external pull-up resistor (10k
typical).
8
3
VCC
Primary power supply. When voltage is applied within normal limits, the device is fully
accessible and data can be written and read.
—
4 - 13
NC
No connect. These pins are unused and must be connected to ground.
©2007-2023 Renesas Electronics Corporation
2
April 4, 2023