TEST AND REQUIREMENTS(JIS C 5201-1 : 1998)
REQUIREMENT
Resistor
TEST
PROCEDURE
DC resistance
DC resistance values measured
Within the specified tolerance
Clause 4.5
<10@0.1V, <100@0.3V, <1K@1.0V,
<10K@3V, <100K@10V,<1M@25V,
<10M@30V
Temperature
Natural resistance change per change in degree Refer to “QUICK REFERENCE DATA”
centigrade.
Coefficient of
Resistance(T.C.R)
R2 R
R
1t2 t1
106 (ppm/C)
1
Clause 4.8
R1 : Resistance at reference temperature
R2 : Resistance at test temperature
t1 : 20°C+5°C-1°C
Short time overload
(S.T.O.L)
Permanent resistance change after a 5second
application of a voltage 2.5 times RCWV or the
maximum overload voltage specified in the above
list, whichever is less.
R/R max. ±(0.5%+0.05)
Clause 4.13
Resistance to soldering
heat(R.S.H)
Clause 4.18
Un-mounted chips completely immersed for no visible damage
10±1second in a SAC solder bath at 260℃±5ºC
R/R max. ±(0.25%+0.05)
Solderability
Un-mounted chips completely immersed for 2±0.5 good tinning (>95% covered)
second in a SAC solder bath at 235℃±5℃
Clause 4.17
no visible damage
Temperature cycling
no visible damage
30 minutes at -55C3C, 2~3 minutes at
Clause 4.19
20°C+5°C-1°C, 30 minutes at +125C3C,
2~3 minutes at 20°C+5°C-1°C, total
continuous cycles
R/R max. ±(0.5%+0.05)
5
Load life (endurance)
Clause 4.25
70±2ºC, 1000 hours, loaded with RCWV or
Vmax,1.5 hours on and 0.5 hours off
R/R max. (1.0%+0.05)
R/R max. (1.0%+0.05)
Load life in Humidity
Clause 4.24
1000 hours, at rated continuous working voltage in
humidity chamber controller at 40C2C and
90~95% relative humidity, 1.5hours on and 0.5
hours off
Bending strength
Clause 4.33
Adhision
Resistors mounted on a 90mm glass epoxy resin
PCB(FR4); bending : 3 mm, once for 10 seconds.
R/R max. ±(0.5%+0.05)
Pressurizing force: 5N, Test time: 10±1sec.
No remarkable damage or removal of the
terminations.
Clause 4.32
Insulation Resistance
R≧10GΩ
Apply the maximum overload voltage (DC) for
1minute
Clause 4.6
Dielectric Withstand
Apply the maximum overload voltage (AC) for 1 No breakdown or flashover
minute
Voltage
Clause 4.7
Page 7 of 8
WFxxK_V02
Feb-2013